smoothed engine bays

Here's how I did mine. http://mustangaddiction.com/pics.htm?bay2.html

I took some poster board and cut out the design I wanted, then transferred that to some sheet metal and cut and bent it to fit. Then I welded it in and used bondo to smooth out the rough spots.

If you don't want to go that far, just fill in the small holes that you don't need with the welder and use some sheet metal to fill in the larger holes. A light coat of bondo will smooth out any imperfections. You can also use bondo to fill in any holes you think you may need later. That's what I did with for the STB holes on the strut towers.

damn, wish i had the patience and know-how to do that during my engine swap... looks clean!!