Steeda Pullies/Steeda Timing Adjuster

[Mr GT 02]

Ok my fellow mustang fellahz

I am debating on getting the Steeda Pullies and Steeda T/A. and having both installed at the same time......Has anyone had any problems with this set-up? and what degree should I have them set the T/A at?
Thanks fellahz

 

[my_03GT]

No problems what so ever, one of the best mods I have done(did them at the same time). I have timing set at 14, when I was running it at 16 I was getting a small amount of hesitation. I believe the instuctions also say on 99 and up GT's recommends no more than 14.

 

[Mr GT 02]

Ok thanks mayun.

 

[01'TRUE BLUE GT]

I have both and have had some trouble because of them ... the rubber just melts off my rear tires now.

 

[wickedgt70]

Great mod when done together. Decent mod when only underdrives are done.

Timing depends on what gas you run. If 93 octane, start at 16 and go up until it pings; then back off a little. Run timing as high as possible without pinging.

 

[StngStr]

what the hell is "mayun"?

 

[quiksilver98]

14* is perfect for my 2v, I tested from 11*-14* and 14* is the best.

 

[Mr GT 02]

Please excuse muh Slang "mayun". Mayun is Man. Sorry for any confusion I have triggered into your brain .

 

[mag_wheels]

Steeda pulleys netted me 9 rwhp. Don't have the t/a, I have a chip...

 

[Slapyo]

those are the only 2 engine mods i have done to my car. i have had no problems with them at all. my timing adjuster is set at 16* right now and i run on 91 octane. i have a dyno with those mods, the link is in my sig.

 

[Bulldog6Z6]

make sure you do them both at once, I did them seperatly and got 2 little gains, if i would have done them both at once im sure i would have been more impressed

 

[53BigDog]

a definiate! I love mine. I'm running at 10-12 right now cause of the dan gas prices but I will go back up to 14 when that 93 octane cames below $2/gal