Stock springs are tough.
WHat i did was dangerous, so only try it at your own risk.
I used a spring compresor to compress the spring just far enough to slip it in place. Then i used long hose clamps to hold the spring compressed. I used about 20. Some guys use wire. It held, and i was able to put it back in.
But like i said, it's dangerous so try it at your own risk.
The proper way to install stock springs is to disconnect the A-arm at the k-member and connect the strut to the spindle. Place the spring in the perch and jack the arm up into position and try to line the bolts back up.