• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Symptoms of a failing oil pump?

  • Thread starter Thread starter Black Sun 5.0
  • Start date Start date Jun 30, 2008

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jun 30, 2008
#1
  • Jun 30, 2008
  • #1
The title says it all. Thanks.
 

ShortThrow50

Member
Oct 22, 2006
923
2
16
Pa
Jun 30, 2008
#2
  • Jun 30, 2008
  • #2
low pressure. no pressure. noisy pump
 

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jun 30, 2008
#3
  • Jun 30, 2008
  • #3
Definition of noisy? Squeaks/squeals on start, perhaps?
 

ShortThrow50

Member
Oct 22, 2006
923
2
16
Pa
Jun 30, 2008
#4
  • Jun 30, 2008
  • #4
Black Sun 5.0 said:
Definition of noisy? Squeaks/squeals on start, perhaps?
Click to expand...

you shouldnt be able to hear your oil pump at all. carefull what your listening too though. in the past i have misdiagnosed oil pump noise with something else. also, i have only has one oil pump go bad and that was on an old ass truck thatwas losing pressure and i only assume the rest from other readings that turned ot to be bad pumps. give this thread a coupl more hours and im sure some other bad oil pump victims will chime inthis tread to help out
 

LiquidGT

Member
Oct 8, 2007
368
0
16
Near STL hell
Jun 30, 2008
#5
  • Jun 30, 2008
  • #5
Used to have a Tempo a long time ago, the motor sounded fine then the oil pump just went out while on the highway.


Are you going by the factory OP gauge?
 

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jun 30, 2008
#6
  • Jun 30, 2008
  • #6
I'm still on the factory gauge, but it just started dipping.
 

LiquidGT

Member
Oct 8, 2007
368
0
16
Near STL hell
Jun 30, 2008
#7
  • Jun 30, 2008
  • #7
Before you give any more concern, change the sending unit, its only $10-20 bucks.

Or you could get one of those mechanical Sunpro gauges from AZ for $20 and put it on the cowl vent temporarily.
 

Dino Dino Bambino

15 Year Member
Jun 13, 2007
1,672
89
79
Cyprus
Jun 30, 2008
#8
  • Jun 30, 2008
  • #8
Noise from a failing oil pump is almost unheard of. It's water pumps that'll often make noise when they're failing. The following are more common signs of oil pump failure:

1. Steady decrease in oil pressure over time. Usually the result of gradual oil pump wear where oil pressure will be low at idle and at higher rpm. May also be accompanied by rod/main bearing wear.
2. Fluctuating oil pressure. Most common reason for a truly fluctuating oil pressure is a sticking oil pressure relief valve, but a fluctuating dashboard gauge is almost always caused by a bad sending unit that's sending false information to the gauge.
3. Sudden loss of oil pressure. Almost always the result of a broken or twisted oil pump shaft.

If you have a low oil pressure at idle but at least 40psi from 2000rpm upwards, the most likely cause is worn rod/main bearings. If an oil pump can generate at least 40psi of oil pressure from 2000rpm upwards it's definitely still good.
 

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jun 30, 2008
#9
  • Jun 30, 2008
  • #9
FYI: When I rev the engine or drive at higher rpms, the gauge does not indicate higher pressure. Also, how can one tell if the bearings are worn. What totally sucks is the fact that this engine only has 13,000 on it, but other issues with the car could have resulted in damage. Thanks.
 

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jul 1, 2008
#10
  • Jul 1, 2008
  • #10
Bump
 

Dino Dino Bambino

15 Year Member
Jun 13, 2007
1,672
89
79
Cyprus
Jul 1, 2008
#11
  • Jul 1, 2008
  • #11
Black Sun 5.0 said:
FYI: When I rev the engine or drive at higher rpms, the gauge does not indicate higher pressure. Also, how can one tell if the bearings are worn. What totally sucks is the fact that this engine only has 13,000 on it, but other issues with the car could have resulted in damage. Thanks.
Click to expand...

Verify your oil pressure readings with a mechanical oil pressure gauge. If they're normal, it's likely your factory oil pressure gauge sending unit is bad. If they're low even when you rev the engine up, the most likely reason is either a worn oil pump or an oil pressure relief valve that's stuck partially open. In both cases you'll need a new oil pump.
 

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
Jul 1, 2008
#12
  • Jul 1, 2008
  • #12
Sounds good, thanks.
 
You must log in or register to reply here.

Similar threads

P
Repeated P2004 DTC trouble code with no apparent symptoms
  • poehitman
  • Mar 11, 2026
  • SN95 V6 Mustang Tech
Replies
2
Views
193
SN95 V6 Mustang Tech Mar 12, 2026
poehitman
P
G
Crazy fuel issue lifting fuel rails
  • greenhornponyguy
  • Oct 30, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
6
Views
427
1996 - 2004 SN95 Mustang -General/Talk- May 18, 2026
bmmckl
Fox Turn signal flasher keeps failing
  • keel
  • Jul 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
10
Views
161
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 9, 2026
Noobz347
S
Engine How does oil make its way into the front sump?
  • Sock_Monke
  • May 10, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
886
Fox 5.0 Mustang Tech May 22, 2025
Chuckster101
C
L
For Sale 2003 White Ford Mustang Convertible For Sale $7,000
  • LemonStealingHorse
  • May 6, 2026
  • SN95 Mustangs For Sale (1994-04)
Replies
0
Views
142
SN95 Mustangs For Sale (1994-04) May 6, 2026
LemonStealingHorse
L
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?