Thermostat Issues

Foxfirst846

Member
Jan 24, 2017
87
3
8
So I am falling into previously discussed issues.. I have a bolt broken off in bottom of the intake. Housing has been removed. I tried drilling it out with an easy out too. My question is this; Can I use in weld or something along those lists bed to glue the thermostat housing to intake. I'm just trying to get through this year before rebuilding engine with new parts. Any advice us greatly appreciated!! I'm gonna try again to remove the bolt. But looking at other options if I can't get it out..
 
Uh oh ! Are you talking about the lower thermostat housing bolt....the one you can't get a straight shot to ?

The easiest way I found to deal with a broken bolt there is to pull the accessories, and timing cover...then you can get straight to it. It'll have to be drilled out straight and tapped or helicoiled.

You could always pull the intake but that's more of a hassle to me. My intake gaskets aren't stock though...so I would opt for replacing a cheap timing cover gasket over having to order new upper and lower intake gaskets. Either way it's a lot of work.

I don't know of a glue that will hold the heat and 16 to 18psi reliably.
 
  • Like
Reactions: General karthief
What type of manifold is it?

If stock or gt40, I'd just pick another lower up and plan for a quick lower swap on a sat morning

I would t trust driving on some sort of temp repair that isn't a drill/tap or helicoil
 
Thanks everyone for replies! I have the edelbrock 5.0 performer upper and lower intake I think lower says 3820 on it. Yes it's the lower bolt I had no problem getting to it. But when tightening down I snapped it. I tried to drill it out and retap it. However I went in crooked. So at this point I think my options are to weld it on for a permanent fix. Or maybe some jb weld to last this summer till I rebuild in the fall. I think if I put a hell coil in there I risk snapping lower intake as it's pretty thin already... Thoughts??
 
Replace the lower intake. I wouldn't trust JB Weld to hold. And to weld the thermostat housing to the intake would require removal of the lower intake anyway. I would also buy a torque wrench and make sure you use the correct torque specs when tightening the bolts down next time. It also helps to use anti-seize on the bolt threads to keep them from corroding.