throttle body studs?

W

wytstang

Mustang Master

Mar 14, 2004

4,988

4

78

Summerville,SC missing South Fl. weather :(

Apr 4, 2004

#1

• Apr 4, 2004

• #1

In the summer I plan on finally putting my cobra intake on ( purchased in early December ). I was looking at the stock intake while i has retighting my header bolts, and i wondered how are you soposed to remove those studs without damaging the treads . There is no small notch that they give you to help remove them at least i don't see one. any help is appreciated

 

G

greg@berkeley

Founding Member

Aug 30, 2002

1,172

0

0

minnesota / university of california, berkeley

Apr 4, 2004

#2

• Apr 4, 2004

• #2

can't you just use two nuts tight against each other and use a wrench on the inner nut? that should work fine, unless i misunderstood your question.

 

HoofnIt

Founding Member

Jan 8, 2001

1,175

0

36

North Carolina

Apr 4, 2004

#3

• Apr 4, 2004

• #3

I was thinking the same thing as I will need to transfer my stock ones over to my polished Cobra intake. Greg-that is exactly how I thought of getting them off. I see no other way to do it.

 

W

wytstang

Mustang Master

Mar 14, 2004

4,988

4

78

Summerville,SC missing South Fl. weather :(

Apr 4, 2004

#4

• Apr 4, 2004

• #4

greg@berkeley said:

can't you just use two nuts tight against each other and use a wrench on the inner nut? that should work fine, unless i misunderstood your question.

Click to expand...

You understood just fine thanx for the reply

 

G

greg@berkeley

Founding Member

Aug 30, 2002

1,172

0

0

minnesota / university of california, berkeley

Apr 4, 2004

#5

• Apr 4, 2004

• #5

no problem, glad i could help! good luck on the swap, it's pretty straight forward. i think it's covered in the faq thread, too.