Throw-out Bearing in Fork

[Ocalafox]

Hey guys,

AOD to T5 swap in process. Anybody have a clear picture of the throw-out bearing installed in the clutch fork? I think I have it in correct but would like a little photo verification. My Chilton book drawing isn't clear and the swap article doesn't have a picture.

Thanks,

vann

 

[5spd GT]

The throw out bearing "fat end" will go towards the pressure plate (engine) and it clips on the back of the fork with the clips. Hope that gives you a better idea...I don't have a pic of it...

If you check on www.centerforce.com they have a picture how to properly install the throwout bearing somewhere in their online instructions when you search for clutches for "our" cars...