Tilt Wheel Causing No Start?

woodsnake · May 28, 2013

I have a no start condition with my 67 Cougar XR7. Not all that different than a similarly equipped Mustang. I removed my complete duraspark ignition, and replaced it with a Pertronix that I had laying around.
Still no start. Engine spins freely, like it has no compression. Fuel down the carb, and no hint of any attempt to run.

Any one have any input? I am really getting angry at this car.....

horse sence · May 28, 2013

i have had a worn out bearing in the top of the column cause horn and signal problems but not starting problems. the ignition doesnt run through the column ,it sounds like the red and black wires that go to the neutral safty switch. on a standard transmition they just have a jumper conection. is there power to the coil when the key is in the on position?also check the I post on the starter solenoid with the key on

woodsnake · May 28, 2013

I should have added that it is a tilt-away column. Sometimes I still think faster than I type.

horse sence · May 28, 2013

if it is an automatic the shifter may be slightly out of adjustment.
i still dont think the tilt away column could interfear with the ignition.
ignition should be its own power source.

woodsnake · May 28, 2013

The shifter bushings are new in the shifter.
I have a thread going on mc.net, about the same no start condition. I had driven the car behind the house, and then it just hasn't started since then! I had a duraspark set up that was working fine-or so I thought. I tried jumping battery voltage straight to the coil, and nothing. I have jumped the stock factory tach to itself. Still nothing. No hint of a spark in the cylinders. I removed and replaced the duraspark with an extra pertronix I had laying around, and no change. Perhaps both electronic distributors are bad?

horse sence · May 28, 2013

a lot of people seem to having trouble with pertronix .i use unilite dist. in mine only problem i have had was accidently shorting out one module

woodsnake · May 28, 2013

I have a unilite, that I was saving- I think I have everything that one needs to run the unilite..I was holding off until I could more easily afford to buy the surge protection module..

Iamdiffrnt · May 28, 2013

Was it starting fine with the new bushings in the shifter? The linkage or the neutral safety switch on the trans may have been adjusted to work with the sloppy shifter, and now that it's tight, may be just a touch off.

Just a thought.

candphall · May 28, 2013

Tilt wheel can cause a no start problem. Reseat and try again.

woodsnake · May 29, 2013

Well, the car has been started-and runs on fuel from the carb. It is not drawing fuel yet from the tank. The pump is new, but has been dry for over a year now...Tilt wheel in this case was not the problem. There are some mystery electrical issues that need to be solved however.

Tilt Wheel Causing No Start?

woodsnake

horse sence

woodsnake

horse sence

woodsnake

horse sence

woodsnake

Iamdiffrnt

Member

candphall

Active Member

woodsnake

Similar threads

Tilt Wheel Causing No Start?

Member

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency