Timing cover questions

jete

New Member
Jul 23, 2006
57
0
0
Lexington Kentucky
Im taking a 302 out of a 90 lsc and im putting it in my 83 and switching to carb'ed. The lsc motor does not have a provision for the manual fuel pump though, so am I going to need to get an external fuel pump and regulator? Anything else small like this I need to watch out for? Will the stock water temp sensor and oil pressure sensor work? Can I use the duraspark II with the motor as well? Just replace the distributor? I have a distributor for a 351w will it work in the switch? Also what would be the best way for hooking up an electric fan to my setup. Should I put in a switch or set it on a 'run' wire?
 
The distributor for the 351 will not work. You will find it easier to get a timing cover out of the j/y for an older engine that already has the mechanical fuel pump cutout. If you want, you can also diy and use a dremel/die grinder and just grind open the fuel pump passage. You will also need to add the fuel pump drive cup to your cam. Do you have a fried 302 in the car now? if so just get the timing cover and fuel pump cup from it. If you are going for big hp then just go with the electric pump and regulator setup. The duraspark should have no issues running in the new engine. Is the LSC engine a roller cam motor? If so, all you should really have to do is change the gear on your old distributor to work with the new engine. I think that the firing order will be different from the 83 though. You should be able to just change it on the cap since you are going carbed though. Hope this helped and I didnt confuse you.
 
So if I grab a distributor off a older 302 and take the gear off the lsc 302 and put it on the old one it should work then right? Just make sure the older one is a vaccum advance one? Also I dont have a fried 302 so Im not sure about what you mean about the cup on the cam. I take it the roller cam wont work on the fuel pump regardless of if I get the right cover. What im getting from this is I cant use the roller cam with this setup. I wanna keep the stock cam so should I just go for the external fuel pump and regulator? I do plan on upgrading later on so I think this would be better, right? Also if im putting a edlebrock carb on top what should my regulator be set for? Thanks for the reply.
 
The cup is just an ecentric that bolts on to the front of the cam. I am not sure if the roller cam has provisions to bolt it on though. As far a fuel pressure goes, I am not sure. I am running FI. The old distributor with the LSC gear should work though.