my car has been down for about a year.. got a little in over my head.. but the project is getting going.. parts are all purchased.. but tires are needed..
I have welds..
I have a basic street rite upfront with a 25in diameter..
in the back I have Hoosiers
Tire, Quick Time D.O.T., P 275 /50-15, Bias-Ply, 11.6in width 26.10 in. tall
when I drive the car aggressively or hit a bad bump.. the rear fenders bite the rear tires.. about an inch from the outside of the tire.. so they are getting replaced..
I want to go to a regular 275 street tire they run about an inch thinner which might make up where the tire is getting bit.. also I have access to a fender roller.. so I think I am good on the fender side.. but a 275 street tire on the inside? will a 10.70 in. wide tire fit on the inner fender?
any advice is appreciated..
I have welds..
I have a basic street rite upfront with a 25in diameter..
in the back I have Hoosiers
Tire, Quick Time D.O.T., P 275 /50-15, Bias-Ply, 11.6in width 26.10 in. tall
when I drive the car aggressively or hit a bad bump.. the rear fenders bite the rear tires.. about an inch from the outside of the tire.. so they are getting replaced..
I want to go to a regular 275 street tire they run about an inch thinner which might make up where the tire is getting bit.. also I have access to a fender roller.. so I think I am good on the fender side.. but a 275 street tire on the inside? will a 10.70 in. wide tire fit on the inner fender?
any advice is appreciated..