Trick flow high ports, mild cam, stock pistons???

[95CobraMike]

Does anyone have any experience with trick flow high port heads? would the valves clear stock pistons with a small/mild cam (comparable to trick flow stage 1 cam/ wolverine 1190 .493/.510 lift 212/222 lsa 112)

id like to hear from anyone who has this setup or close to this setup, anyone who has tried a setup like this and it didnt work for them, or if you know of anyone running this setup... let me know

Thanks

 

[95CobraMike]

no one has any experience with these heads?

 

[yellow1995Cobra]

I cant think of any in this forum section with those heads.

Id try the 5.0 section, or the corral.

 

[mytight95]

my friend has an 89 gt he had the old iron high ports i believe it had 2.05 valves, you have to run different headers with them, and he had to flycut the pistons.

I am not sure on the chamber size though, so he could have had some really milled heads etc. But i don't think from what i have seen from him that they would work.


I can ask about it though

jason

 

[95CobraMike]

ok... the ones i was looking at have 2.02 valves and they are aluminum
combustion chambers are 64cc on these...
hummmm

 

[95snoozer]

flycut

why not just get twisted wedges if you are looking for a deal?

 

[95CobraMike]

twisted wedges are the plan, i just found some high ports for a really good price...

i am just looking at all of my options

 

[mytight95]

my buddy said with his cam .588, .57?, he still had to have the pistons worked... he did say that the heads were 60cc though.... so you might could figure it up... he said he had .125 reliefs put in them...


jason