If anyone could help here, that would be great. I have a 91 fox LX 5.0 Hatch. My turn signals are not working at all. My hazards work fine. From the inside and out, changed out the relays for both the hazard and turn signal, located in the fuse box, and behind the glove box. The hazard one worked fine, and the turn signal one still didn’t work. Changed the ignition switch and that didn’t help either. I’m kinda lost here and would love some help. Would this be a fix, what’s in this video?
Turn signals not working at all, but hazards do. 91 fox LX 5.0
- Thread starter Zeke1995
- Start date
-
Sponsors (?)
Appreciate the quick response! Do you think that could be the case? even if the high beams, and wipers work?
Do the turn signal bulbs light up but don't blink (insert blinker fluid joke here) or not light up at all?
So the hazards work fine, so I’m taking it the bulbs are good. And the hazards work on the dash as well. But as far as the turn signals, no clicking noise, no lights on the dash , and no lights from outside. I have changed both relays, checked the fuse (but I will check it again with my multi meter, replaced ignition switch.
thatblackfoxbody
Member
Pull out the hazard switch from the dash, the wires are notorious for depinning from this connector and causing the turn signals not to function. If that's the case the wires will be loose and fall out of the plastic connector when you pull out the switch.
If this is the issue, you can fix it by either trying to hold the wires together with tape/zip tie, or you can purchase a new connector from lmr.com or other vendor. Good luck.
thatblackfoxbody
Member
Hi there,
I’m not sure if this will help, but I have a 1995 GT that I bought last autumn, so it’s still fairly new to me.
It came with a weird aftermarket alarm system that’s been spliced into a bunch of wires behind the dash. I’m planning to remove it this winter, but for now I’m having an issue that sounds a bit like yours.
When I turn on the hazard lights, nothing happens — not even the hazard switch itself blinks. But as soon as I turn the hazard switch off, all my regular turn signals work just fine. That’s how I’ve been driving all summer. Every bulb is working normally.
Maybe you’ve got an aftermarket alarm system too, like mine? Just a thought.
I’m not sure if this will help, but I have a 1995 GT that I bought last autumn, so it’s still fairly new to me.
It came with a weird aftermarket alarm system that’s been spliced into a bunch of wires behind the dash. I’m planning to remove it this winter, but for now I’m having an issue that sounds a bit like yours.
When I turn on the hazard lights, nothing happens — not even the hazard switch itself blinks. But as soon as I turn the hazard switch off, all my regular turn signals work just fine. That’s how I’ve been driving all summer. Every bulb is working normally.
Maybe you’ve got an aftermarket alarm system too, like mine? Just a thought.
Have you tested all wires are good? Use a test light to see where you’re loosing power.
I had a problem with my backup lights and when I pulled the carpet and checked the wires, I found a break in the wire and the wire insulation wasn’t damaged. Would never had found it if I hadn’t probed the wire insulation
Similar threads
