UD Pulleys

Makdaddymac · Jun 22, 2008

hey guys i ordered some blueoval UD pulleys for 70.00 price range......and the altnaotr pulley wont fit on the alt........... will this mess things up? i cant return it cause i tried to make the whole bigger with no luck any ideas or suggestions? that is some good steel.. can i ditch it, or will it mess up the the size and etc......

Saleen0679 · Jun 22, 2008

If your belt tension is good then you should be fine. You may even be better off since you probably won't have the charging problem that some UD alt pulleys can cause. Quite a few guys don't run the UD alt pulley for that reason.

Mustang5L5 · Jun 22, 2008

I'd run an ASP overdrive alt pulley instead so you don't have charge probs

DucatiRdr · Jun 22, 2008

I have only the crank and water pump UD pulleys on my car and there aren't any issues. Well, now that I run a 130 alternator. Prior to that the lights would dim at idle and I had a hard time keeping the battery charged with the limited fair weather driving that I do with the car.

Actually, the stock pulley on the 130 alternator was very similar in size to the UD alternator pulley that I had on the stock alternator.

Makdaddymac · Jun 22, 2008

yah i figured judging from the size.....i think the main thing is the crank and water pump... just wanted to make sure that quarter inch of diamater difference wasn't the critical of keeping the battery charged

RUNINAGT · Jun 27, 2008

I think I put the stock alt puley back on?????? Been so long can't remember. lol

UD Pulleys

Makdaddymac

New Member

Saleen0679

Mustang5L5

That is…until I whipped out my Bissell

DucatiRdr

New Member

Makdaddymac

New Member

RUNINAGT

Member

Similar threads

UD Pulleys

Makdaddymac

New Member

Saleen0679

Mustang5L5

That is…until I whipped out my Bissell

DucatiRdr

New Member

Makdaddymac

New Member

RUNINAGT

Member

Similar threads

Privacy & Transparency

Privacy & Transparency