This block was bored out a year or two(or ten) ago, and the guy i bought ti from doesnt know the specs. I used a T-sytle bore guage and basic vernier calipers. i centered the T guage and locked it, then measured with calipers. This is the part where i wish i took notes in HS..it is 1 mark past the 4 inch mark, and right in between the 1st and 2nd mark, (using the 0 on the top slider), i think every mark past the 4" mark on the main body is .25", right? if so then its 4.25" and the line on the slider that lines up perfecty with any line below it is 13, so i add 4.25" and .13" and get 4.38..except an overbore would be 4.030", right?? or am i doing this wrong? thanks for any help i might just go buy some cheap digital calipers
~Mark~
~Mark~