Vert hydraulic line setup

[im2damncool]

I recently had to change the hydraulic lines that run the vert top. But I didn't pay attention the the routing order. ie: top line of right cylinder to vert motor to bottom line of left cylinder. Anybody know how they're supposed to be routed?

 

[srothfuss]

Man that is a good question. I don't remember, I'll run out and check though...

Edit: I looked but it was either too dark or I was too cold. I can check again tomorrow afterwork but your probably right in the middle of the setup.

 

[im2damncool]

Anything you can do would be very much appreciated. I have them hooked up now but I think the order's wrong cause it's fighting me if I try and pull the top up.

 

[srothfuss]

Sorry man I forgot all about this thread... I can't really see a whole lot... It appeared that the lines in the front of the motor (fiting facing the hood) go to the bottom of both cylinders.

How are they set up on your car currently?

 

[im2damncool]

Can anybody verify that? I don't want to hook it up wrong and blow a fitting when I try it.

 

[Blakthorn]

did you fill up the vert fluid while you were in there?

 

[im2damncool]

ya, fluid level's good. And I found a post that tells how to bleed the lines once they're hooked up right.