• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Very Odd Problem Someone PLZ Help Me

  • Thread starter Thread starter MyCARneedsHelp
  • Start date Start date Apr 22, 2004

MyCARneedsHelp

Founding Member
Apr 24, 2002
658
0
16
Plainfield,IL
Apr 22, 2004
#1
  • Apr 22, 2004
  • #1
Its a 88 GT Auto, Motor was just rebuilt pan to intake. Still Speed Density also

My problem is that while i drive the car feels jumpy. Its not that it shakes but feels like im getting rear ended millions of times. When i hit the gas hard it goes away and the motor takes off fine... and fast . When it idles it idles high then lowers to about 700 then is fine... after about 2 minutes and it gets warm the idle shoots up/ then down till it about dies. BUT...

I just replaced my t.p.s, radiator,rad cap and put some bbk shortys on. Would anything i bough be faulty?

Also when i drive somtimes the car lags and ill give it more gas and still will continue to go slow until i punch it, then i hear a loud bang and it takes off fine ... Im not exactly sure if this is more then 1 problem but you guys are the best. - Andy
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 22, 2004
#2
  • Apr 22, 2004
  • #2
aod tranny needs to go. or maybe the TV cable needs to be adjusted. take it to a tranny shop and have them look at the cable. if it is out of whack for long it will destroy the tranny
 

MyCARneedsHelp

Founding Member
Apr 24, 2002
658
0
16
Plainfield,IL
Apr 22, 2004
#3
  • Apr 22, 2004
  • #3
but would that also cause it to die out after idleing for a lil while? thanx lots for your help!
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 22, 2004
#4
  • Apr 22, 2004
  • #4
no tat would be something on the throttle body i think it's the cai. it needs to be taken off and decarbonized or cleaned. i really don't know about all this efi stuff. that is why i got a carb system
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 22, 2004
#5
  • Apr 22, 2004
  • #5
no tat would be something on the throttle body i think it's the iac. it needs to be taken off and decarbonized or cleaned. i really don't know about all this efi stuff. that is why i got a carb system I MEANT IAC not cai
 

StangLou

Active Member
Jul 9, 2003
1,264
0
36
Holly Springs, NC
Apr 22, 2004
#6
  • Apr 22, 2004
  • #6
cheapest thing you can try is to take off you CAI up to the tb. open up the tb and spray some carb cleaner into the tb. get a shop rag and reach in and wipe out all you can reach in the tb. If you want, take off the tb completely and clean it this way, then take your rag and clean as much into the intake as you can. I had a very jumpy idle on '90 and a guy at advance told me to do this. It would almost die on me as well. Tried this lil trick and it ran PERFECT. I have to do it every 6-8 months... for some reason I tend to build up a lot of crap in my tb .
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 22, 2004
#7
  • Apr 22, 2004
  • #7
if you are going to do it this way do not use carb cleaner because it can eat off the special coating inside the TB. that is why on the can it says not to use it. they make special TB cleaners for this. i don't know what the coating is for but it is there for some reason.
 

MyCARneedsHelp

Founding Member
Apr 24, 2002
658
0
16
Plainfield,IL
Apr 22, 2004
#8
  • Apr 22, 2004
  • #8
ok will do, hope it works. If not somone told me my fuel injectors are going, this could be true? thanx for all your help guys
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 22, 2004
#9
  • Apr 22, 2004
  • #9
i doubt that but you could take them off and clean them up
 

StangLou

Active Member
Jul 9, 2003
1,264
0
36
Holly Springs, NC
Apr 22, 2004
#10
  • Apr 22, 2004
  • #10
The can I got said TB/Carb cleaner so I guess its fine for either or
 
You must log in or register to reply here.

Similar threads

Engine Surging idle on start-up
  • keel
  • Aug 11, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
785
Fox 5.0 Mustang Tech Oct 31, 2025
keel
8
Engine Rough idle and aggressive sputtering when accelerating
  • 88vertible
  • Aug 13, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
1K
Fox 5.0 Mustang Tech Dec 13, 2025
Jarhead67
J
B
I need help with an 06
  • boviske underwood
  • Oct 30, 2025
  • Services - Tuning, Welding, Mechanic, Body Work...
Replies
0
Views
463
Services - Tuning, Welding, Mechanic, Body Work... Oct 30, 2025
boviske underwood
B
K
Intense Shaking problem
  • KP_NewEdge
  • Jun 11, 2025
  • SN95 V6 Mustang Tech
Replies
1
Views
269
SN95 V6 Mustang Tech Jun 11, 2025
gkomo
A
Rough idle - cylinder 1 and 6 misfire HELP
  • austindavies935
  • Jul 24, 2025
  • SN95 4.6L Mustang Tech
Replies
12
Views
638
SN95 4.6L Mustang Tech Jul 24, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?