Vibration/Rough Take-off

[617thmp]

I have a 2001 Bullitt and it has a very rough vibration that I can feel in the gearshift and the clutch pedal. The car is vibrates/shakes very bad when pulling out in 1st gear, but clears up after that. I am getting code p0131, p0135, P0141 with code reader which I know is 02 sensors, but it was doing it before the codes where thrown and my tech guy says that o2 sensors will not cause this type of miss/vibration. I looked for vacuum leaks and have found none. It has a new clutch, pressure plate, throwout bearing. Any suggestions would be appreciated.

 

[COramprat]

I'm betting flywheel. Did you get it resurfaced when you had the clutch done?

 

[Tazzy]

+1 on the flywheel

 

[bboylobo]

i would def. double check the clutch installation. did you install it? if not have the person or shop resonsible doubel check their work.

 

[Night Shifter]

i had the same problem...turned out to be the clutch... go check it!