I'm running a GM style sensor about 4 inches before the throttle body
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
My plan is to move it right before the tb as well at some pointI moved mine to before the tb as well... 170* in #5 runner cruising now I see 110* under the same condition.
Looking at the data from @MikeH686 and comparing to your data is actually pretty interesting that the temps are relatively similar as measured in the runner on being non intercooled and the other being intercooled. even though Mike is having a tough day with his reading comprehension... LMFAO!My plan is to move it right before the tb as well at some point
Sent from my iPhone using my fingers while my auto correct makes me seem illiterate

Good question.I've been watching this thread. Seems like I should move mine, too. Anyone know what size the threads are on the IAT ?
Oddly enough, Ford did move the IAT sensor to the intake tube before the throttle body in the '94-'95 5.0. The '94-'95 computers are different, however, I am not sure if they made any changes to the computer to compensate for the different IAT sensor location.Why would you move the IAT sensor to someplace that does not register actual intake air temp? The sensor in the intake manifold just before the intake valve would give the more accurate reading of what the air temp is before it gets into the engine. There is a reason Ford put it there, don't you think? Moving the sensor to before the throttle body will only skew the temp reading to a number that is not what is actually going into the engine. The temp sensor will read what the temp of the air that is flowing past the sensor, not the temp of the intake manifold.
With an aluminum intake it is very possible. If you like I have dozens of datalogs to verify.New cars pretty much all have plastic intake manifolds nowadays, so alleged heat soak is not an issue. Ford has thousands of hours of data regarding air inlet temps. If heat soak was possible, it would be only during hot idle conditions and the corresponding data that has been gathered could easily transfer real intake air temp to the measured ambient temp data. Once any rpm is induced into the engine, the resulting increased air flow past the sensor would eliminate any "heat soak".