What intake for my 93 5.0

[aussiesmg]

OK guys what intake has the following requirements.

Flows good up to 7000 rpm

Has a low hood clearance, my project is not a stang body

works with the usual mods, 70mm TB, 80mm MAF, ported decked heads, B303 cam, high volume oil pump, crane timing chain, headers, light flywheel and so on. It is a T5.

Steve

 

[BlownFiveLiter]

Your bigger problem than the 7000RPM is thinking you'll get that much out of a B303... The B cam will probably be well past its useful RPM range long before 7k, and I don't think you'd see it even if you ran an X or Z cam. Any short runner (Edelbrock RPM, TFS Track Heat, etc.) intake should get you close to that point, however. Your best bet for an intake that'll flow well to that sort of RPM would probably be a box upper.