What intake??

jstang209

20+ Year Stangneter :roc</strong><span class=
Jun 3, 2004
640
2
18
Stockton 209
what intake would be good with brand new stock heads/cam? i plan to upgrade the heads/cam but later tho.. im just asking because i heard a good intake with stock heads would just hurt performace right? or did i hear wrong?
 
I would think a Trickflow intake even with the stock heads would really do your car some good. Then down the road when you replace the heads and cam, they will be better mods because you already did the intake. You probably need more advice from somebody that actually has fuel injection lol.
 
I (as always) suggest the e-brock preformer

very good runner out of the box, works well with stock components, leaves enough room for heads/cam mods, they can be ported, and they got this new design out where you don't have to fight with that god forsaken center bolt for like 20min
 
I like my edelbrock performer intake. Very easy to install and flows great. I do have heads/cam as well, but I have heard the performer is the way to go with stock heads. Either that or a cobra intake. The street heat would work well too, but some say its a bit overkill for stock heads.
 
unless you plan on keeping it stock internal I think the cobra is a waste. why pay $400 for a manifold, then get a $400 port job when you could of gotten a $400 something else first time around and been done with it.


I just don't support the trick flow becouse I have had to many friends get them and make no low end torq out of them. I knew a guy with an intercooled prochargen notch that ran really good with the tfs but is car diddn't weigh alot and he was running some pretty high boost
 
Edelbrock intake and a 70mm TB should start you in the right direction. The street heat is a really nice intake but unless you got the heads to take advantage of it... low end torque will suffer.
Kevin
 
NUTCASE said:
unless you plan on keeping it stock internal I think the cobra is a waste. why pay $400 for a manifold, then get a $400 port job when you could of gotten a $400 something else first time around and been done with it.

aint that the truth! Cobra intakes are a thing of the past like the B303 cam, there's better stuff out there now
 
vikingpower said:
Cobra intakes are a thing of the past like the B303 cam, there's better stuff out there now

Man, I can prove you wrong in SO many ways - you need to spend some time at my site, especially in the dyno section of the photos.

I would suggest a good used Cobra/Explorer or Performer above all others.

But what do I know...................... :shrug:
 
tmoss said:
Man, I can prove you wrong in SO many ways - you need to spend some time at my site, especially in the dyno section of the photos.

I would suggest a good used Cobra/Explorer or Performer above all others.

But what do I know...................... :shrug:

:stupid:

Before my H/I/C swap I had an explorer intake. I got it for $200 off the corral. At the time I was very happy with it. I felt a very noticable SOTP increase when ran with stock heads/cam. I ended up selling it because I wanted the Performer intake for the looks and to match my heads better. IMO you can't go wrong with a cobra or explorer intake. Look for a used one. The GT-40 is good too but is too much $$ for what it is.