While the car is out of commission....

[Rick's Fords]

I am going to clean up the engine bay. Removed AC condeser, and the 2 lines going from it, the canister on the passenger side fender. Will probably be painting a few things as well, just trying to decide what.

Once I get the new computer, she gets plugs, wires, cap, rotor, replacing all of that fragile crap they call vaccum lines with some real ones, going to drop the k-member and put on a new oil pan gasket, and anything else I run into on the way. Will probably install the rest of my underdrive pully kit as well, it currently only has the water pump pully on.

Any other suggestions?

 

[Glaze]

coil over kit complimenting k-member (or just lowering springs)
engine mounts

also could go all out like i did with old project, fill in holes in compartment and really paint it show quality.