wideband..

[stangster50]

im looking for a nice wideband to start the tuning of my stang... its a 90' notch. i will be using the tweecer r/t, and im completely new at the tuning game.. i just want to make sure, befor i dish out $300 that this is going to work with the tweecer.. i will be able to datalog off of this guage right? i just wanted to know everyone's opinion, as i can get a good discount...

here it is..
http://autometer.com/cat_gaugedetail.aspx?gid=3606&sid=4

thanks!

 

[MrXCESSIVESPEED]

I use the innovate LC1 with the XD16 gauge.....it should work with the tweecer...it works with the PMS if i connect a feed to it and load the proper file for it.

 

[strtrcr50]

Yes it can. Blue wire to positive for logging, blue with a black tracer for logging ground. You, will however, need a data q or wire it into your egr sensor wire. I'd say to use a data q. Only $25 for serial or $50 for usb hookup. What software are you usikng with the tweecer? I use bineditor and the transfer was right for my plx. However, that appears to use a 0-4 v output, so you will prob have to config that in your software. Good Luck.

 

[strtrcr50]

This is how I have mine hooked up to a dataq.