I have some extra pipe laying around and I need to make some reducers for my exhaust to go from 3inch-2.5. I was wondering if something like this would work?
My dad said the pockets that wouldn't flow would make it worse. Basically I would cut a 2.5 inch hole in a piece of scrap sheet metal, weld the 2.5 inch pipe to it, then weld the sheet metal onto the 3 inch pipe.
PS yes I am badass at paint....
My dad said the pockets that wouldn't flow would make it worse. Basically I would cut a 2.5 inch hole in a piece of scrap sheet metal, weld the 2.5 inch pipe to it, then weld the sheet metal onto the 3 inch pipe.
PS yes I am badass at paint....