Will these heads work for me?

[thebuckaman]

I am looking to buy a slightly used set of Edelbrock Performer RPM heads on corral. The ad is as follows:

"I have a set of Edelbrock Performer aluminum heads 1:90/1:60 valves. They are pedistal mount and have some minor port and polish work near gasket areas. I had them decked .007" to remove o-ring groves. Heads are still on motor so I don't have pictures yet. Heads have around 2500miles on them and about 250miles since machine work. Thinking about selling to buy some trickflows."

I want to use my stock 1.7 RR and I have a Crane 2031 cam. Will these work for me.

I need your expert guidance! I'm new to this. Car is a 95 cobra...100K, cam, CAI, MAF, and TB. Full Exhaust.
_______________________________________________________________________________________
EDITEDITEDITEDITEDIT

I bought Edelbrock Performers 190 160 with 1.6 crane RR and TF pushrods with a Trickflow Track heat U/L intake.

How much HP can I expect to increse with this?

Thanks.

Thanks!

 

[Grn92LX]

The ad says theyre pedistal mount so your pedistal 1.7 rockers will bolt right on. You will need to measure pushrod length.

 

[thebuckaman]

How much HP do you think I will gain? What are these heads worth?

 

[legalize420]

How much HP do you think I will gain? What are these heads worth?

from what i have seen cobras usually put down between 250 and 270. with those heads i would say between 280-300. probobly worth around 700. not alot of gain for the money spent but you could sell your stock heads to offset some of the cost.

 

[Grn92LX]

Maybe 600 bucks. Are they the revised heads or the old school ones?

 

[thebuckaman]

I bought different heads

I bought Edelbrock Performers 190 160 with 1.6 crane RR and TF pushrods with a Trickflow Track heat U/L intake.

How much HP can I expect to increse with this?

Thanks.