I got my Amazon air gap.intake and it looks pretty good. Im going to clean up the casting flash and install it. I primed my motor and found thebplug on the rear china wall starting to seep. I used aircraft sealant and sunk it down to were I thought it should go. Any suggestions?
Progress Thread Deals are still out there.
- Thread starter mattcrp1
- Start date
Finally got the plug to seal. I used a 3m scotch bright to rough the edge of the plug to rough up and used a liberal amount of this retaining compound. Let it set for 24 hours. Hit it with the prime tool, no leak. Not ashamed to admit i used Gemini to trouble shoot this. How many of you guys us this tool for specs or quick technical questions?
