maybe "stage 1" cams, so that you wouldn't require the spring swap, that should be able to pull your 20-25.nickthegenius said:If cams and springs were a little cheaper, they would fit the category if they were aggressive enough (Comp 270s or VT Engines Stage II). You might even be able to get one of the companies to custom grind something to your specs to insure that the average gain was 20-25hp. However, the cheapest I have ever seen a cam/spring package go is $700.
Not really sure where else you are going to find that kind of power for that money.
StangPro said:I'm just trying to gage what hp per $$ should be.
I'm working on releasing a package of parts that will make a dyno proven 20-25hp and cost less than $500. Or for less than $600, I can get it around 30hp.
Does this seem like a good price for the performance?
StangPro said:Cams would probably fall in that category, but I'm talking about a half hour install too.
JonJon said:Dyno proven 20-25hp for less than $500 with an install time of under an hour? You have my attention...
bold claims indeed. i'd say $35:hpBlev said:You have some peoples attention, can you deliver? This 30 min. install also has my attention. The only ponies I was able to bolt on in 30 min. was either my CAI or my plenum/TB.
mogs01gt said:Nothing will take 30 minutes to install. Hell it takes me ****ing ten minutes to open up a damn air freshner package.
StangPro said:Ok, if you do installs like I do, it may take over a half hour. It seems once I open the hood I end up spending an hour cleaning and figuring out my next mod before I ever touch a wrench.
I'm trying ot put together a package that consists of the following:
For around $500: (20-25hp)
Plenum
75mm TB
100mm full length CAI with fenderwell mounted filter
For around $600 (still working on this price level) (~30hp)
Include a Pro-M MAF
HP numbers are at the wheels. I've dyno tested versus a stock car with only a K&N drop-in filter and we're right at those power levels. I just need to do a few things before I can start selling these;
1. Finish talking to my suppliers to make sure there won't be any surprises and I can meet the cost, quality, power, and rapid delivery to buyers
2. Final dyno test of released parts.
Once this is done in a week or two, what does everyone think?
dmarco_4u said:ah sorry to break it to you buddy but you wont get 25-30 hp with just 3 mods that you can buy seperatly for alot cheaper
Plenum $115 PROB 5-7 HP
75mm throb $110 PROB 3-4 HP
CAI w K&N $65 4-6HP
Pro-M MAF 1-2 HP
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?