Currently piecing together a 351w (357) build to swap into my 1967 coupe.
Here are the specs:
'94 roller block bored 30 over
Racetec forged pistons, -12cc, 4.030
Scat i Beam rods
Stock crank
All ARP hardware
Summit M2008 750 carb
Promaxx Project X heads, 185cc/2.02, 1.6, 58cc
10:1 cr
Performer RPM manifold for hood clearance
Haven't figured out cam shaft yet but looking at the TFS stage 2 or 3 and spinning the motor between 6k-6500.
would like to see 450-475hp at the crank as this will be going through a C6 trans.
My First SBF build so let me know if I'm missing something or could do better!
Here are the specs:
'94 roller block bored 30 over
Racetec forged pistons, -12cc, 4.030
Scat i Beam rods
Stock crank
All ARP hardware
Summit M2008 750 carb
Promaxx Project X heads, 185cc/2.02, 1.6, 58cc
10:1 cr
Performer RPM manifold for hood clearance
Haven't figured out cam shaft yet but looking at the TFS stage 2 or 3 and spinning the motor between 6k-6500.
would like to see 450-475hp at the crank as this will be going through a C6 trans.
My First SBF build so let me know if I'm missing something or could do better!