I have a 1970 Mach 1 with a shaker hood. I order a stencil kit and the center stripe measured about 14 1/2" wide. It's about the same width as the trim ring for the scoop. At car shows other Mach 1 have center stripe that is a little over 15", 15 3/8". That leaves about 1/2" on each side of the trim ring.
Which measurements is correct for a center strip on a 70 Mach 1 with a shaker?
When I called the stencil company they said the 14 1/2" was what Ford gave them.
But yet I see many stock original hoods that have a little wider center stripe.
Can anyone help on determining the correct measurement? Did change the measurement at some point to be inline with the scoop?
Thanks
Which measurements is correct for a center strip on a 70 Mach 1 with a shaker?
When I called the stencil company they said the 14 1/2" was what Ford gave them.
But yet I see many stock original hoods that have a little wider center stripe.
Can anyone help on determining the correct measurement? Did change the measurement at some point to be inline with the scoop?
Thanks