• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

90' Smog Pump Broken

  • Thread starter Thread starter stangpowers
  • Start date Start date Feb 9, 2009
S

stangpowers

New Member
Feb 9, 2009
1
0
0
Feb 9, 2009
#1
  • Feb 9, 2009
  • #1
My smog pump just went out and I'm wondering two things, first, what's the best way to fix it, and second is there a quick fix (like disconnecting it so it will just spin freely) so I can drive in the mean time? I still have my catalytic converter in place and I've heard it will ruin that if I just disengage it permanently along with emission problems. I have not been able to find anything just on how to replace it with a new one (if that's the way I should go), only how to eliminate it. Are there any tricks?
 
S

Slipk911

New Member
May 25, 2006
26
0
0
Bensalem, PA
Feb 9, 2009
#2
  • Feb 9, 2009
  • #2
from what i've heard u can either eliminate it or replace it... mine's been dead in my 2000 for 2 years... didn't break anything besides the Check Engine light being on because of it
 

Maryland Stang

Active Member
Aug 21, 2002
1,656
30
39
Greenville, NC
Feb 9, 2009
#3
  • Feb 9, 2009
  • #3
I don't think you can get it apart without a shop press. I've also never heard of any rebuild kits for them but you never know. A new one is around $60 wherever fine autoparts are sold.
 
M

mavmavv

New Member
Nov 21, 2007
185
0
0
Feb 9, 2009
#4
  • Feb 9, 2009
  • #4
I bet you could put up a want ad and snag one for free.
 

dcurtis

10 Year Member
Jan 19, 2006
688
7
39
Feb 9, 2009
#5
  • Feb 9, 2009
  • #5
If you have no emission testing there you can just remove it all together and run a shorter belt.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Feb 9, 2009
#6
  • Feb 9, 2009
  • #6
Removing the smog pump is OK if you don't have a catalytic converter H pipe. If you do, the lack of a smog pump will cause the catalytic converters to clog and fail.

I have torn (and I do literally mean torn) a smog pump apart. There isn't much you can do to fix them once they seize up or start to make serious noise.


Thermactor Air System
Some review of how it works...

The Thermactor air pump (smog pump) supplies air to the heads or catalytic converters. This air helps break down the excess HC (hydrocarbons) and CO (carbon monoxide). The air supplied to the catalytic converters helps create the catalytic reaction that changes the HC & CO into CO2 and water vapor. Catalytic converters on 5.0 Mustangs are designed to use the extra air provided by the smog pump. Without the extra air, the catalytic converters will clog and fail.

The Thermactor air pump draws air from an inlet filter in the front of the pump. The smog pump puts air into the heads when the engine is cold and then into the catalytic converters when it is warm. The Thermactor control valves serve to direct the flow. The first valve, TAB (Thermactor Air Bypass) or AM1 valve) either dumps air to the atmosphere or passes it on to the second valve. The second valve, TAD (Thermactor Air Diverter valve or AM2 valve) directs it to the heads or the catalytic converters. Check valves located after the TAB & TAD solenoids prevent hot exhaust gases from damaging the control valves or pump in case of a backfire. The air serves to help consume any unburned hydrocarbons by supplying extra oxygen to the catalytic process. The computer tells the Thermactor Air System to open the Bypass valve at WOT (wide open throttle) minimizing engine drag. This dumps the pump's output to the atmosphere, and reduces the parasitic drag caused by the smog pump to about 2-4 HP at WOT. The Bypass valve also opens during deceleration to reduce or prevent backfires.






Computer operation & control for the Thermactor Air System
Automobile computers use current sink technology. They do not source power to any relay, solenoid or actuator like the IAC, fuel pump relay, or fuel injectors. Instead the computer provides a ground path for the positive battery voltage to get back to the battery negative terminal. That flow of power from positive to negative is what provides the energy to make the IAC, fuel pump relay, or fuel injectors work. No ground provided by the computer, then the actuators and relays don't operate.

One side of the any relay/actuator/solenoid in the engine compartment will be connected to a red wire that has 12-14 volts anytime the ignition switch is in the run position. The other side will have 12-14 volts when the relay/actuator/solenoid isn't turned on. Once the computer turns on the clamp side, the voltage on the computer side of the wire will drop down to 1 volt or less.

In order to test the TAD/TAB solenoids, you need to ground the white/red wire on the TAB solenoid or the light green/black wire on the TAD solenoid.

For 94-95 cars: the colors are different. The White/Red wire (TAB control) is White/Orange (Pin 31 on the PCM). The Green/Black wire (TAD control) should be Brown (pin 34 at the PCM). Thanks to HISSIN50 for this tip.

To test the computer, you can use a test light across the TAB or TAD wiring connectors and dump the codes. When you dump the codes, the computer does a self test that toggles every relay/actuator/solenoid on and off. When this happens, the test light will flicker.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Feb 10, 2009
#7
  • Feb 10, 2009
  • #7
I've had the same luck as Joe with tearing into them (I've done a few and none of them stayed quiet for more than several thousand miles). There are tiny bearings in the center of the cams that score or seize to the mainshaft (and can make it a real PITA to get the pump apart, though I just use handtools. Do not put the case in a vice).

The other big issue I've seen is with the vane bushings allowing the vanes to drag on the walls of the pump.

In any case, I'd just get a new or reman'd pump (in that order).

If you do get inside the pump, here's a pic of what you'll see:

 

parrish5o

New Member
Dec 22, 2008
2
0
0
Dirty South
Feb 10, 2009
#8
  • Feb 10, 2009
  • #8
I've been running my car without one for years but I do have an off road h-pipe. And of course we have no emissions testing down here. If you can get away with it just delete it. It will do away with several pounds from the front of your car also.
 
You must log in or register to reply here.

Similar threads

9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
1K
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
Ford truck engine swap issues
  • keel
  • Jul 7, 2026
  • Other Auto Tech
Replies
17
Views
765
Other Auto Tech Jul 13, 2026
General karthief
V
Okay for smog pump to spin?
  • Valicy
  • Sep 28, 2024
  • 1994 - 1995 Specific Tech
Replies
2
Views
353
1994 - 1995 Specific Tech Sep 28, 2024
AeroCoupe
S
Fuel ‘88 GT Runs Rich Cold — Fixes Itself When I Unplug Sensors (ECT, MAF, O2, etc.)
  • Sufarry
  • Nov 6, 2025
  • Fox 5.0 Mustang Tech
Replies
12
Views
1K
Fox 5.0 Mustang Tech Nov 9, 2025
Mustang5L5
B
water pump installation questions
  • B0udreaux
  • Feb 5, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
38
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 28, 2026
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?