• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-

91 GT Need help identifying parts and some issue.

  • Thread starter Thread starter MCMXCI_blkfox
  • Start date Start date Jun 19, 2025
M

MCMXCI_blkfox

Member
Jun 19, 2025
2
2
13
Denver, CO
Jun 19, 2025
#1
  • Jun 19, 2025
  • #1
Hi all! New member. Just purchased a 91 with 38k miles. It has a host of tasteful upgrades but I need some help. I’m have some a/c issues, and cooling issues. Trying to figure out what I have.

First question: I have an upgraded radiator but I’m curious what the other part is in front of the Mishimoto. What is that with the coils in front that faces the grille?

Also, should I upgrade the fan? Seems to be a gap between the stock fan and radiator.




That’s a good place to start. I’ll ask about A/C issues next post.


Thanks!!!
 

Attachments

  • IMG_4855.webp
    116 KB · Views: 44

General karthief

wonder how much it would cost to ship you a pair
20+ Year Stangneter
Aug 25, 2016
27,915
10,563
203
polk county florida
Jun 19, 2025
#2
  • Jun 19, 2025
  • #2
Welcome aboard, I move this down the hall to the fox forums, OH, and fixed the title too.. Anyway, the gap at the shroud and radiator is just fine, and as for those tubes, you have the radiator of course, the AC condenser and the two tubes in front of that is likely power steering cooler tubes, not very efficient but better than nothing I guess.
Cooling issues eh? Check to see if the air damn is still present under the radiator support, just a plastic piece. Then check the clutch fan, cold engine you should feel a fair amount of resistance turning the fan by hand.
The plastic fan blades also crack at the hub so look for that, doesn't effect cooling unless it breaks off and then you're using your AAA card.
Post up a pic or two of this fabulous ride.
Also if you're going by the stock gauge.....they are a 'best guess', you can mount a temporary mechanical gauge, just zip tie that sucker to a wiper arm and hope it don't rain for a while, note temp readings in different driving scenarios, I'm thinking it's not puking coolant on the ground or smoking out the tail pipes.
 
Reactions: Mcmahst
M

MCMXCI_blkfox

Member
Jun 19, 2025
2
2
13
Denver, CO
Jun 19, 2025
#3
  • Jun 19, 2025
  • #3
thanks!

Here she is. I just had the digital dash and gps speedometer installed so I’m hoping it’s just a gauge issue. I do see I still have the airdam. Fan clutch was just replaced. I’m wondering if a vacuum leak could cause it as I’m also having A/C only blowing out of the defrost vents. I just had the motor mounts replaced so I’m wondering if something got damaged during that install.

I’m having my mechanic give it a good test tomorrow to make sure I’m ok. I also have a Wrangler I use for off-roading so I’m used to a money pit!
 

Attachments

  • IMG_4594.webp
    220 KB · Views: 52
  • 6113556269134805612.webp
    445.5 KB · Views: 61
  • image000000.webp
    387.2 KB · Views: 72
  • 2952270668956610251.webp
    260.7 KB · Views: 54
  • IMG_4873.webp
    57.6 KB · Views: 47
  • image.webp
    167.2 KB · Views: 58
  • image.webp
    128.2 KB · Views: 60
  • image.webp
    107.9 KB · Views: 59
Reactions: gkomo and 85GT4V

gkomo

now i can hopefully expect to receive the shaft
Aug 2, 2024
2,164
1,414
133
San Diego, CA
Jun 19, 2025
#4
  • Jun 19, 2025
  • #4
That digital dash is cool. Where is the sensor that feeds the temp gauge hooked up?

As mentioned the mechanical fan is plenty. If all looks good with the shroud, fan, fan clutch, airdam, and side radiator airdams then it’s something else. Could be an air pocket in the cooling system, low on coolant, etc.

Regarding the A/C only blowing out the defrost vents, There is a vacuum line that connects to the top of a valve or something right up/near behind the glovebox. Could see if that’s cracked or popped off.
 

General karthief

wonder how much it would cost to ship you a pair
20+ Year Stangneter
Aug 25, 2016
27,915
10,563
203
polk county florida
Jun 19, 2025
#5
  • Jun 19, 2025
  • #5
Also check the main line from the vacuum tree running to the passenger side along the cowl, it's plastic so it breaks easy.
 
Reactions: Mcmahst
You must log in or register to reply here.

Similar threads

Fox Fuel Pump Issues After Replacement/Upgrade
  • Ryu
  • Jun 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
23
Views
549
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 5, 2026
Ryu
A
Help ID - Turbo GT, SVO differences
  • aldoelmalo
  • Jun 2, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
0
Views
79
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 2, 2026
aldoelmalo
A
C
Fox Need help identifying brake setup
  • Cypher02xd
  • Apr 25, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
138
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 27, 2026
Mustang5L5
M
Could this part be identified?
  • MartinM
  • Jul 8, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
286
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 8, 2025
Shakerhood
Engine 1986 GT Overheating issues
  • 86 5O GT
  • Jan 25, 2026
  • Fox 5.0 Mustang Tech
Replies
18
Views
635
Fox 5.0 Mustang Tech Jan 29, 2026
86 5O GT
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?