• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

95 Stang Firing Hot And Getting Fuel But Won't Start

  • Thread starter Thread starter Swadey95
  • Start date Start date Oct 4, 2016
  • Tags Tags
    1995 all new ignition parts firing hot getting gas help not familiar with the 94-95 5.0
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#1
  • Oct 4, 2016
  • #1
I recently bought a 1995 mustang gt. Thought I'd found a cherry car, it's got 90000 miles and is in excellent condition, one owner which was an older lady. I buy it start driving it home, make it about 40 miles and it dies. After having it hauled home I start the hunt. No fire anywhere, gas to fuel rail but not making it through the injectors. Changed parts in this order. Coil, ignition module, and last pip, which fixed it. I went ahead and bought a new distributer. Ran good for a couple weeks. Ran it kinda low on gas again acquired a little miss. Bought some Lucas, put it in the tank. Drove it a bit and the little miss went away. Parked the car at my girlfriends a couple nights later. Next morning started it up, let it warm a minute or so. Took off and made it about 50 ft. Cranking to start back, it hit a lick a couple times then no more. It's firing hot, getting fuel to rail and through the injectors. Don't have a guage to check pressure but when I hold the bleeder down it has PLENTY of pressure. Don't have a code scanner. Someone please help. Thank you..
 
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#2
  • Oct 4, 2016
  • #2
I recently bought a 1995 mustang gt. Thought I'd found a cherry car, it's got 90000 miles and is in excellent condition, one owner which was an older lady. I buy it start driving it home, make it about 40 miles and it dies. After having it hauled home I start the hunt. No fire anywhere, gas to fuel rail but not making it through the injectors. Changed parts in this order. Coil, ignition module, and last pip, which fixed it. I went ahead and bought a new distributer. Ran good for a couple weeks. Ran it kinda low on gas again acquired a little miss. Bought some Lucas, put it in the tank. Drove it a bit and the little miss went away. Parked the car at my girlfriends a couple nights later. Next morning started it up, let it warm a minute or so. Took off and made it about 50 ft. Cranking to start back, it hit a lick a couple times then no more. It's firing hot, getting fuel to rail and through the injectors. Don't have a guage to check pressure but when I hold the bleeder down it has PLENTY of pressure. Don't have a code scanner. Someone please help. Thank you..
 

Moosee1955

Active Member
Sep 30, 2016
267
55
38
Oct 4, 2016
#3
  • Oct 4, 2016
  • #3
Easiest way and lazy way to see if it's fuel related, get a can of starting fluid, give a good shot into intake. If it's fuel it will fire for a second or so then die. If it doesn't start, pull one of the plug wires and stick a spark plug in it ground against head or intake bolt have someone crank motor. Should spark if ignition is good. If not you'll need to troubleshoot ignition. Coil/ tfi module, etc. kinda weird that in the beginning of post you said fuel goes up to rail but not injectors. How is that even possible? If fuel pumps from tank through filter all the way up front to rail it's got to flow to injectors. I would buy/ borrow a fuel pressure guage. Do a key off/ on running test if you get it running. Check connections at fuel pump relay/ fuse. You could have corrosion or a bad relay. You might want to replace relay and fuse with new ones. Also get ahold of a code reader, their could be other things going on you need to know about. Don't be a parts changer, please diagnose your problem


Sent from my iPhone using Tapatalk
 
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#4
  • Oct 4, 2016
  • #4
Moosee1955 said:
Easiest way and lazy way to see if it's fuel related, get a can of starting fluid, give a good shot into intake. If it's fuel it will fire for a second or so then die. If it doesn't start, pull one of the plug wires and stick a spark plug in it ground against head or intake bolt have someone crank motor. Should spark if ignition is good. If not you'll need to troubleshoot ignition. Coil/ tfi module, etc. kinda weird that in the beginning of post you said fuel goes up to rail but not injectors. How is that even possible? If fuel pumps from tank through filter all the way up front to rail it's got to flow to injectors. I would buy/ borrow a fuel pressure guage. Do a key off/ on running test if you get it running. Check connections at fuel pump relay/ fuse. You could have corrosion or a bad relay. You might want to replace relay and fuse with new ones. Also get ahold of a code reader, their could be other things going on you need to know about. Don't be a parts changer, please diagnose your problem


Sent from my iPhone using Tapatalk
Click to expand...

Reason I said that about the fuel rail and injectors was because rail had plenty of fuel but injectors was dry as a bone
That's when the pip went out. Noe plugs are soaking wet just after a couple cranks. Didn't check all the plugs, but the 5 I pulled was. I'm leaning toward fuel regulated. What's ur thoughts on my new info sir?
 

Moosee1955

Active Member
Sep 30, 2016
267
55
38
Oct 4, 2016
#5
  • Oct 4, 2016
  • #5
Pull the vacuum hose on fuel regulator, if any fuel comes out replace regulator. The other test is with fuel pressure gauge installed on rail, when you pull vacuum line with motor running, a functioning regulator will jump up about 5 points. If it doesn't or jumps way up replace regulator.


Sent from my iPhone using Tapatalk
 
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#6
  • Oct 4, 2016
  • #6
Moosee1955 said:
Pull the vacuum hose on fuel regulator, if any fuel comes out replace regulator. The other test is with fuel pressure gauge installed on rail, when you pull vacuum line with motor running, a functioning regulator will jump up about 5 points. If it doesn't or jumps way up replace regulator.


Sent from my iPhone using Tapatalk
Click to expand...
 
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#7
  • Oct 4, 2016
  • #7
When I pulled vacuum lines off. The one on the side of the regulator seemed damp with gas and most definitely a strong gas smell. I hooked the hose up to the regulator side, got in the car and turned the key on and off several times. It made a noise like air or squirting out. Didn't see no gas though. Definitely made a weird noise.
 
S

Swadey95

Active User
Oct 3, 2016
11
0
1
Clarkson Ky
Oct 4, 2016
#8
  • Oct 4, 2016
  • #8
I replaced the regulator and she's back up and going. Thanks for the help everyone.
 

Moosee1955

Active Member
Sep 30, 2016
267
55
38
Oct 4, 2016
#9
  • Oct 4, 2016
  • #9
Glad you figured it out. Fuel in the vacuum line for the regulator is first sign to replace it.


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.

Similar threads

T
Help with a 95 5L crank no start
  • TheBubbaJoe
  • Nov 4, 2025
  • 1994 - 1995 Specific Tech
Replies
3
Views
465
1994 - 1995 Specific Tech Nov 5, 2025
AeroCoupe
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
599
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
A9L on 94 engine, no priming injector pulse?
  • Wallyman
  • Jun 17, 2024
  • Other Auto Tech
Replies
11
Views
1K
Other Auto Tech Jun 24, 2024
Wallyman
J
Engine No power after idle
  • JustinTilley86
  • Aug 10, 2024
  • Fox 5.0 Mustang Tech
  • 2
Replies
34
Views
2K
Fox 5.0 Mustang Tech Sep 23, 2024
General karthief
Progress Thread Giving an abandoned 88 GT project a new chance at life
  • jaketractor
  • Jan 9, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
27
Views
2K
Fox 5.0 Mustang Tech Jul 20, 2025
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?