AFR165 users: answer asap!!

[homerojr]

Sorry to ask you such a silly question, however, there´s a correct side for the heads (a head for the driver side and another for the passenger side), or they can be installed at any side. Is there an identification or number on these heads to diifferentiate them?
Thanks for any info

 

[AznStanger3v]

the bolts that hold the accessory brackets...... those holes they go in are your indication

 

[Stangfreak95]

Either side dude. Just put the plugs where they need to be.

 

[homerojr]

Thanks for the help. I was asking because I´m porting my cobra intake to match the intake ports, and so I definetely must get the heads in their respective position. I have p-heads and p-headers, and due to the spark plug position being somewhat diferent, so are the headers (though I was told they would fit on my new heads if I keep them; if some money is left I should go for lt´s). Sorry again, just to see if I got the point: so in the AFR165 the plugs are pointing to the front of the vehicle?
Any picture would be greatly appreciated.

 

[rockin_rick]

When you get a set of 165's, you get 2 identical heads. Either side. The spark plugs will face forward on the pass side, and back on the drivers.

Rick

 

[Stangfreak95]

Thanks for the help. I was asking because I´m porting my cobra intake to match the intake ports, and so I definetely must get the heads in their respective position. I have p-heads and p-headers, and due to the spark plug position being somewhat diferent, so are the headers (though I was told they would fit on my new heads if I keep them; if some money is left I should go for lt´s). Sorry again, just to see if I got the point: so in the AFR165 the plugs are pointing to the front of the vehicle?
Any picture would be greatly appreciated.

Your heads are suppose to come with (2) plugs. Those plugs will need to be inserted in each head on the side where all your pulleys, alternator, power steering are. If you're not gonna run the air pump stuff, then you'll need (2) other plugs to go in the back of the heads, where the firewall is to delete the bracket that joins both your heads together.

 

[homerojr]

Thanks a lot everybody!! I guess I got it right. My setup will be non-emissions, and I´m aware I´ll have to plug the holes at the back of the heads.
Thanks again.