Hey Guys,
I am trying to have a graphic made for my convertible that will look similar to the production SSC, SC or SA10 slash graphics that were on door and fender.
I don't want to make the exact same graphics, but the Saleen graphics are aesthetically pleasing so I thought that would be a good place to start.
I was wondering if anyone would be able / willing to do a little measuring for me.
What I am looking for is a measurement:
1. Length up the side of one of the slashes
2. Length of the top of one of the slashes
3. The distance between the slashes
4. If possible and you have a protractor handy, could you measure the angle at which the slash runs?
It would be VERY much appreciated!!
Thanks in advance!
- Jeff
I am trying to have a graphic made for my convertible that will look similar to the production SSC, SC or SA10 slash graphics that were on door and fender.
I don't want to make the exact same graphics, but the Saleen graphics are aesthetically pleasing so I thought that would be a good place to start.
I was wondering if anyone would be able / willing to do a little measuring for me.
What I am looking for is a measurement:
1. Length up the side of one of the slashes
2. Length of the top of one of the slashes
3. The distance between the slashes
4. If possible and you have a protractor handy, could you measure the angle at which the slash runs?
It would be VERY much appreciated!!
Thanks in advance!
- Jeff