any ideas

KAGGRIFF

New Member
Nov 20, 2008
4
0
0
I have a internal engine noise. best why that i can discribe it is a rod knock. problem is the noise goes away after the car is warm. With electronic ears I have pinpointed the noise to be the loadest between cylinder 7 and 8 right about the freeze plug area. any help or ideas would be great.
 
COULD BE A WRIST PIN

I HAD AN 88 TBIRD WITH 5.0 WITH LOTS OF BOLT ONS THAT WOULD KNOCK BUT IT WAS QUIETER THAN A ROD KNOCK

AND WHEN IT GOT WARMED UP IT WENT AWAY

I DROVE THE S*** OUT OF THAT CAR FOR 5 YRS TILL I GOT SOMETHING NEWER
NEVER HAD A PROB. BUT THAT MAY NOT BE YOUR CASE. SOUNDS SIMILAR:shrug:
 
well i also thought it might be a broken skirt. this is a 347 bottom end with forged internals. world windsor sr heads. you are right about the noise not being as load as a rod knock but the same kind of sound to me. just seems to be getting worse and it is frustrating on a motor with less than 6k
 
well i also thought it might be a broken skirt. this is a 347 bottom end with forged internals. world windsor sr heads. you are right about the noise not being as load as a rod knock but the same kind of sound to me. just seems to be getting worse and it is frustrating on a motor with less than 6k
DO YOUR PISTONS HAVE A FLOATING PIN WITH A SPRING LOCK OR ARE THEY PRESSED IN?
 
I really dont know. bought the car with the engine already built. I have a feeling i am just going to have to pull it and look. but with a noise that goes away it is somewhat chasing a ghost.