anyone ever snapped the crankshaft off right behind the harmonic balancer?

91notchback5.0

New Member
Oct 17, 2006
5
0
0
The other day i hit it in first gear and then a loud noise so i rolled into the median and got out and saw my belt, pulley and harmonic balancer in the middle of the road. I went and got it and it was still connected to the shaft. the shaft snapped right off behind the balancer. whats up with that? any help would be appreciated.
 
91notchback5.0 said:
The other day i hit it in first gear and then a loud noise so i rolled into the median and got out and saw my belt, pulley and harmonic balancer in the middle of the road. I went and got it and it was still connected to the shaft. the shaft snapped right off behind the balancer. whats up with that? any help would be appreciated.
Same exact thing happened to my friend with a 90 GT but we could never figure it out. His car was stock except for cobra intake and exhaust. Freaky aint it? Sorry I do not have an answer but you aint the only one.
 
Just remeber you'll need to spin the new crank and have the rods, pistons, pins etc all weighed to see if you will need to rebalance or not. You can not just swap them out...


MD stang is right usually it is due to rpm, stock balancer or a blower.
 
Bad balancer and worn bearings probably caused this. Happens all the time to old 5.0's.

Don't even consider trying to re-use the engine, new crank or not, it's probably alot more messed up than you think. Oil pan and timing cover are likely gone too. Not to mention the block may now be cracked.

Here in NJ junkyards, 5.0's complete are only around $500. Meaning you could have your car up and running in a day or two.

If you get a complete engine with harness and all accessories, you can part out the old engine for around $250, meaning the running engine only cost you $250.