• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-

Anyone have a car lift in a garage?

  • Thread starter Thread starter limp
  • Start date Start date Feb 5, 2025

limp

wrap a little cheese around it and its a done
5 Year Member
Oct 4, 2020
5,469
2,903
173
71
Florida
en.m.wikipedia.org
Feb 5, 2025
#1
  • Feb 5, 2025
  • #1
Does anyone have a car lift in a home garage with a 9 ft ceiling?
What obstacles or recommendations would you suggest? Was thinking a 4 post lift.....
I am aware that I would not be able to lift a car all the way up ( 9 ft ceilings,) but I notice youtuber Chris Sullivan sits in a rolling shop chair and rolls around under his while repairing them..
Yes I know a shop would be the best, but its not going to happen and I am really tired at my age ( will be 70 in April) lying on the ground..... I know I could get more done if I could get under them easier...
Anyone done this?
 

2000xp8

SN Certified Technician
Aug 8, 2003
8,031
1,622
194
NJ
Feb 5, 2025
#2
  • Feb 5, 2025
  • #2
I have an 11'2 ceiling and a bendpak hd7p and it's good enough for my mustang and for me to walk under the car the entire winter without ducking (i'm 6'1).
If i were to lose 2ft i'd probably switch to a 2 post or a scissors style (i'd recess that in the floor). Not sure if i would use a quickjack or not, i've yet to see one in person.
There is fine line where ducking is worse than laying down.

For arguments sake, i went out and measured down 2ft from the bottom of the lift with the car sitting where i leave it, a couple inches from the ceiling.
It would be too low to do anything on the underside.

Dont' forget either, good hydraulic slide jacks are really expensive too. I have one and then a jacking plate that i can put jackstands if i need both ends in the air which so far has been almost never.

Let's not forget the part that many miss, your garage door needs to go up too. I had to convert my door to a high lift, it doesn't interfere with my car, but it would with an SUV. If your rails are low, that could be yet another issue.

I'd probably go a different route than a 4 post or if there is more room above your garage modify the ceiling, you can get more space depending on how it's framed.

Edit: The reason i say 2 post is because then you are only under the car itself with the wheels hanging, another quick measure reveals that would get over a foot back from the bottom of the lift to the side body.
 
Reactions: 91AOD5.0LX and limp

limp

wrap a little cheese around it and its a done
5 Year Member
Oct 4, 2020
5,469
2,903
173
71
Florida
en.m.wikipedia.org
Feb 5, 2025
#3
  • Feb 5, 2025
  • #3
2000xp8 said:
I have an 11'2 ceiling and a bendpak hd7p and it's good enough for my mustang and for me to walk under the car the entire winter without ducking (i'm 6'1).
If i were to lose 2ft i'd probably switch to a 2 post or a scissors style (i'd recess that in the floor). Not sure if i would use a quickjack or not, i've yet to see one in person.
There is fine line where ducking is worse than laying down.

For arguments sake, i went out and measured down 2ft from the bottom of the lift with the car sitting where i leave it, a couple inches from the ceiling.
It would be too low to do anything on the underside.

Dont' forget either, good hydraulic slide jacks are really expensive too. I have one and then a jacking plate that i can put jackstands if i need both ends in the air which so far has been almost never.

Let's not forget the part that many miss, your garage door needs to go up too. I had to convert my door to a high lift, it doesn't interfere with my car, but it would with an SUV. If your rails are low, that could be yet another issue.

I'd probably go a different route than a 4 post or if there is more room above your garage modify the ceiling, you can get more space depending on how it's framed.

Edit: The reason i say 2 post is because then you are only under the car itself with the wheels hanging, another quick measure reveals that would get over a foot back from the bottom of the lift to the side body.
Click to expand...
thanks for your reply, lots of good info there....
I have only been around 2 posts but thought a 4 post might be easier on ' an old man"..... Good point about additional height gained...
Have you watched Chris Sullivan roll around under his cars... He has a two post come to think of it..
Got a little PO the other day while trying to change the front differential fluid in my Chevy Pickup... I have always done maintenance on my cars, mainly because I know its done right with the fluids and parts I want used.... Getting old sucks....
 

General karthief

wonder how much it would cost to ship you a pair
20+ Year Stangneter
Aug 25, 2016
27,949
10,587
203
polk county florida
Feb 5, 2025
#4
  • Feb 5, 2025
  • #4
Working under a car on a lift has it's own 'old man' pains, but then I'm a little taller than Limp.
Yeah, get'n old sucks, make the best of it.......wear a helmet
 
Reactions: limp

limp

wrap a little cheese around it and its a done
5 Year Member
Oct 4, 2020
5,469
2,903
173
71
Florida
en.m.wikipedia.org
Feb 5, 2025
#5
  • Feb 5, 2025
  • #5
Did somebody say Helmet???
 

LILCBRA

I wish I didn't have all of these balls in the air
Mod Dude
Dec 6, 2005
6,401
5,385
194
54
Corn County USA
Feb 5, 2025
#6
  • Feb 5, 2025
  • #6
These are an option.

MaxJax®

The M7K. The bigger, badder MaxJax®. Everything you loved about the M6K is back, but now with an even higher lifting capacity. Our engineers found a way to let you safely lift up to 7,000 lbs. while still retaining a minimal footprint. Thanks to its unique portable two-post design, the MaxJax...
maxjax.com
 
T

topbliss

Member
Mar 14, 2009
6
6
13
Feb 6, 2025
#7
  • Feb 6, 2025
  • #7
I have a bendpak 4 post in my garage and love it. I store a car up to too.
 

limp

wrap a little cheese around it and its a done
5 Year Member
Oct 4, 2020
5,469
2,903
173
71
Florida
en.m.wikipedia.org
Feb 6, 2025
#8
  • Feb 6, 2025
  • #8
LIke most projects, do it half a$$ed, it will always be half a$$ed
 

90sickfox

Wasn't a pretty sight...and I've got big hands
SN Certified Technician
Mar 2, 2015
6,945
5,816
213
48
Feb 6, 2025
#9
  • Feb 6, 2025
  • #9
I've got a harbor freight scossor lift in mine. It works out well. My garage has an 11ft ceiling but maxes with a fox at around 9ft. Doesnt come close to the door motor or hardware. Its the same one thats sold by a binch of other bramds...they just paint it a different color.




This is all the way up with the car on 2x4 blocks on the lift arms. I did have to make ramps because my other car is too low to clear it. Recessing in the floor would be nice....but expensive and a lot of work. I put a quick coupler on the hydraulic line so i van move the pump out of the way.

I can easily fit under it on a rolling stool. Its a plus that I can move it anywhere.
 
Reactions: limp and LILCBRA

RaggedGT

Been here over a DECADE and still no CT
Mod Dude
Jul 20, 2014
4,739
3,188
203
41
Taylorsville ky
youtube.com
Feb 6, 2025
#10
  • Feb 6, 2025
  • #10
90sickfox said:
I've got a harbor freight scossor lift in mine. It works out well. My garage has an 11ft ceiling but maxes with a fox at around 9ft. Doesnt come close to the door motor or hardware. Its the same one thats sold by a binch of other bramds...they just paint it a different color.




This is all the way up with the car on 2x4 blocks on the lift arms. I did have to make ramps because my other car is too low to clear it. Recessing in the floor would be nice....but expensive and a lot of work. I put a quick coupler on the hydraulic line so i van move the pump out of the way.

I can easily fit under it on a rolling stool. Its a plus that I can move it anywhere.
Click to expand...
Those plants Medicinal?- Of Recreational?
 
Reactions: 90sickfox

General karthief

wonder how much it would cost to ship you a pair
20+ Year Stangneter
Aug 25, 2016
27,949
10,587
203
polk county florida
Feb 7, 2025
#11
  • Feb 7, 2025
  • #11
RaggedGT said:
Those plants Medicinal?- Of Recreational?
Click to expand...
Plastic
 
Reactions: 90sickfox and RaggedGT

hoopty5.0

mechanicus terribilis
15 Year Member
Dec 14, 2010
7,788
6,940
214
SW Houston
Feb 7, 2025
#12
  • Feb 7, 2025
  • #12
I have a 2 post 9k lift in my shop but have 12' ceilings. The brand is Atlas.
 
Reactions: 90sickfox and RaggedGT
You must log in or register to reply here.

Similar threads

S
Drivetrain Downshifting from 3rd to 2nd issue
  • Scott_S
  • Apr 23, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
782
Fox 5.0 Mustang Tech Jun 14, 2026
Mindseye007
Considering widening my rear wheels, would like to verify my thoughts on fitment
  • 2000xp8
  • Jul 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
24
Views
479
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Today at 12:32 PM
gkomo
B
Where to go from here on my build…
  • B0udreaux
  • Jul 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
210
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
1979 Pace Car Build- #887
  • darryl27529
  • Aug 6, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
24
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 4, 2026
Willybill32
Mustang II 4 cyl gear hunting and possibly messed up vacuum system
  • oesterreicher
  • May 31, 2026
  • 1974 - 1978 Mustang II Talk & Tech
Replies
11
Views
316
1974 - 1978 Mustang II Talk & Tech Jun 14, 2026
manicmechanic007
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?