Anyone using a taurus 3g alternator?

Like it says, I picked one up. But before I install was wondering if you ran into any problems or slight mods needed. I don't want to get halfway through my install only to find out I can't use it. It's my d.d. so I must get it done during one install day. I've read a few people say it might need a spacer for the pulley, but they never indicated what size. Then I read many people debate about being able to use UD pulleys, is this true? Any help on this topic would be great. It's pretty hard to come by a cheap sn95 alt in my town, so my 3g came from a taurus. Thanks
 
I would read Monte Smith's article and Mustang Central's article. Jrichker has a very comprehensive post about performing the upgrade, including what wiring supplies you might wish to purchase.

The actual swap takes about 30mins-1 hour, mainly depending upon how you clearance the bracket. Time taken, of course, can vary. It will not take long though.

Good luck.
 
HISSIN50 said:
I would read Monte Smith's article and Mustang Central's article. Jrichker has a very comprehensive post about performing the upgrade, including what wiring supplies you might wish to purchase.

The actual swap takes about 30mins-1 hour, mainly depending upon how you clearance the bracket. Time taken, of course, can vary. It will not take long though.

Good luck.
I've search high & low on articles about the taurus 3g. I could only find 2 or 3 articles about the taurus 3g & 6g, but both say they had difficulty with spacing the pulley. I know it fits into the bracket and even saw a pic from cardomain of someone with a 6g installed (tried contacting him from but no luck). It's just the issue of spacing the pulley so the belt doesn't fly off. Anyone?:shrug:
 
1996 and up 3g alternators are a little different than 94-95 3g`s.
They have a different case and different pulley spacing,(none of the 3g sites tell you this).

ASP told me their 1-7/8" OD alternator pulley will not fit a 96` up 3g.I asked about using a 5/8" washer as a spacer,but they said it would push the pulley grooves too far out causing the belt to walk off.They can custom make one for $80.:shock:

Maybe someone here has tried using a spacer/washer on a smaller 2g pulley or OD pulley on a 96`and up 3g and can tell you how it worked.(if it worked).I`m just going by what ASP told me.

The 3g alternators come with huge 2-1/2" diameter pulleys that are too big for underdrive pulley use on a 5.0L stang,so your probably going to want a smaller one.