B&M Ripper 5-Speed install????????

[MustangMatt1966]

Hey guys, i am usually over in the classic forum, but i figured u guys know more about this than we do over ther. I just ordered a B&M Rpper 5-Speed short shifter for my t-5 trani that i have in my classic 1966. I was wondering if any of you knew a site that had a step by step install for this product. I have heard they are pretty easy to install and can be done in about a few hours of time. I know you all have wisdom beyond imagination and can come up with some answers for me. thanks again.

Matt

 

[HISSIN50]

not sure about a write up (im too lazy to look for you since im on dial-up ).

on ours: the insulation boot is held on with four 10mm (IIRC) bolts. the shifter has four 13 MM bolts.

transfer or install a new shifter cup bushing (on the bottom of the shifter - it goes on the bottom of the shifter handle where it mates with the trans).
seal it up and adjust the stops. that is the super crude version.

good luck and bump for ya.

 

[MustangMatt1966]

thanks hissin50...anyone else????

 

[Henceforward]

thanks hissin50...anyone else????

This is not a B&M install, but it is step by step...
http://forums.stangnet.com/showthread.php?t=528042

Here is another install how to.
http://mustang50magazine.com/howto/138_0408_shifter_install/index.html

Here is a B&M ripper How-To, found this one by searching google...
http://www.fordmuscle.com/archives/2000/02/t5/index.shtml

 

[MustangMatt1966]

Thanks sooooo much, that is great, just what i was looking for!!!!!!!!!!!!!!