brake fitting straightening

[50gt1988]

Ok, I'm doing a rear disc brake conversion on my car and I got the MC conversion T from Matt at www.svo73mm.cjb.net but when it screws into the prop. valve the side brake port opening faces the fender wall when its tightened. How do I get it to tighten to were its facing the rear of the car were it's supposed to face?

 

[50gt1988]

Ttt

 

[50gt1988]

anyone??

 

[50gt1988]

t

 

[ALMOST STOCK]

anyone??

I think this will help answer your ?

http://www.corral.net/forums/showthread.php?t=620021&highlight=weatherhead

 

[Shakerhood]

Maximum Motorsports makes a kit too and you can adjust it to point whichever direction you want it to.

 

[Asha'man]

Hit up your local Napa stores and find a Weatherhead 7914 that threads correctly with your specific proportioning valve. I pulled a PV from the junkyard to use to make sure all my fittings fit correctly, and then just used that PV in the swap.

Brian

 

[ratrapp]

asha'man's right.i had to do the same thing when i got my 3-2 port kit from matt also.