Broken rocker arm bolt?

meangreen92

New Member
Aug 25, 2004
13
0
1
My car started blowing grey smoke today and idling like crap. I pulled off the valve cover to discover that one of the bolts holding the rocker on had broke. The car still has e7s and the stock 5/16 rockers. I put in a Crane 2020 (530 lift 204/208 duration) in last year and have not had any problems until now. About a month ago I put in new stock rockers since the stock one were so worn. I'm starting to think that the old worn rockers may have been what kept this from happening. I replaced the bolt after spending hours trying to get that damn broken bolt out but now I'm blowing gray smoke and I think the same thing is going to happen again as it getting louder again. Any ideas or suggestions would be greatly appreciated.
 
My car started blowing grey smoke today and idling like crap. I pulled off the valve cover to discover that one of the bolts holding the rocker on had broke. The car still has e7s and the stock 5/16 rockers. I put in a Crane 2020 (530 lift 204/208 duration) in last year and have not had any problems until now. About a month ago I put in new stock rockers since the stock one were so worn. I'm starting to think that the old worn rockers may have been what kept this from happening. I replaced the bolt after spending hours trying to get that damn broken bolt out but now I'm blowing gray smoke and I think the same thing is going to happen again as it getting louder again. Any ideas or suggestions would be greatly appreciated.

The Crane 2020 has 208/216 duration at .050" lift, not 204/208.

Did you replace the springs on the E7TE heads at the same time, or are you still running stock springs?

The recommended matching spring for that cam is Crane # 99841,and has 118lbs on the seat at a 1.950 installed height, 375lbs open at 1.380, and 457 spring rate.

If you are still using the stock E7TE heads, than you are only getting approximately 80lbs on the seat and around 215lbs open. The result of using stock springs with that kind of a cam, would be terrible valvetrain stability and harmonics, and could undoubtedly lead to busted rocker bolts (they are only 5/16" after all) and valve float, among other wear issues.

Lots of people just slap a cam in the block and pay no attention to the valve springs, which are absolutely critical. Are you one of those people?
 
The Crane 2020 has 208/216 duration at .050" lift, not 204/208.

Did you replace the springs on the E7TE heads at the same time, or are you still running stock springs?

The recommended matching spring for that cam is Crane # 99841,and has 118lbs on the seat at a 1.950 installed height, 375lbs open at 1.380, and 457 spring rate.

If you are still using the stock E7TE heads, than you are only getting approximately 80lbs on the seat and around 215lbs open. The result of using stock springs with that kind of a cam, would be terrible valvetrain stability and harmonics, and could undoubtedly lead to busted rocker bolts (they are only 5/16" after all) and valve float, among other wear issues.

Lots of people just slap a cam in the block and pay no attention to the valve springs, which are absolutely critical. Are you one of those people?

Yes 208/216 thats what I meant and no I am not one of "those people" thank you very much. I bought Crane cams 444212 which came with the springs. Like I said I have been running this thing for about a year with any problem. The stock springs were were so worn out it felt like an ignition miss. I thought I might as well put a cam in since it was getting new valve springs. I'm not retarded. I'm just asking for help.