• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Car dies randomly at idle

  • Thread starter Thread starter Stanger007
  • Start date Start date Jun 1, 2005
Prev
  • 1
  • 2
First Prev 2 of 2

Koniz

New Member
Apr 3, 2005
137
0
0
Geneseo, IL
Jun 21, 2005
#21
  • Jun 21, 2005
  • #21
Now I am just quoting one of my uncles good friends that is has been a mechanic for 30+ years and he was saying on the 302 distributers the stater will go bad and sieze up on the shaft and that would make those same symtoms I have the same problem with my 94 that is a stick when it dies I usually start and it will try to die and I will wrap the RPMs to about 4000 and it will be fine I would try that
 

Stanger007

Founding Member
Sep 26, 2001
2,015
2
46
Baton Rouge, LA
Jun 21, 2005
#22
  • Jun 21, 2005
  • #22
Here's the laundry list of what I've changed/cleaned:
IAC (did this tonite)
ECT (in intake)
ACT (in intake tract)
New O2s
Cleaned air filter (cleaned MAF a couple of weeks after reoiling)
New Fuel Filter
New Distributor
New Coil
New Plugs (at .054)
New 9mm Ford Racing wires
MSD Cap/Rotor
Fuel Pump (added gauge too see above post)
Cleaned MAF
Cleaned T/B
New PCV Valve/Filter/Grommet
Good grounds
New negative cable
No vacuum leaks
Timing rechecked tonite - at 13-14
No codes last time I checked (2wks ago)

98% of the time it idles great. Rock steady. Love it.

Then there's that 2% where (almost ALWAYS when warm) I start it and put it in gear and the RPMs go up to about 1000 and down to about 450ish and unless I give it a touch of gas it dies. It will also occasionally die at a stoplight just like someone turned the key off. After dying it *always* cranks right back up with no problems.
 

DoHcHoLlIdAy01

New Member
May 28, 2005
46
0
0
Los Angeles, CA
Jun 22, 2005
#23
  • Jun 22, 2005
  • #23
Stanger007 said:
Here's the laundry list of what I've changed/cleaned:
IAC (did this tonite)
ECT (in intake)
ACT (in intake tract)
New O2s
Cleaned air filter (cleaned MAF a couple of weeks after reoiling)
New Fuel Filter
New Distributor
New Coil
New Plugs (at .054)
New 9mm Ford Racing wires
MSD Cap/Rotor
Fuel Pump (added gauge too see above post)
Cleaned MAF
Cleaned T/B
New PCV Valve/Filter/Grommet
Good grounds
New negative cable
No vacuum leaks
Timing rechecked tonite - at 13-14
No codes last time I checked (2wks ago)

98% of the time it idles great. Rock steady. Love it.

Then there's that 2% where (almost ALWAYS when warm) I start it and put it in gear and the RPMs go up to about 1000 and down to about 450ish and unless I give it a touch of gas it dies. It will also occasionally die at a stoplight just like someone turned the key off. After dying it *always* cranks right back up with no problems.
Click to expand...

I still think a tune on the CPU is needed. The stock Ford CPU has problems with it from the factory. It is not too expensive to have a custom chip burned.
 
B

blackEagle

Founding Member
Dec 12, 2001
116
0
16
Calumet City,IL
Jun 22, 2005
#24
  • Jun 22, 2005
  • #24
Stanger007 said:
Here's the laundry list of what I've changed/cleaned:
IAC (did this tonite)
ECT (in intake)
ACT (in intake tract)
New O2s
Cleaned air filter (cleaned MAF a couple of weeks after reoiling)
New Fuel Filter
New Distributor
New Coil
New Plugs (at .054)
New 9mm Ford Racing wires
MSD Cap/Rotor
Fuel Pump (added gauge too see above post)
Cleaned MAF
Cleaned T/B
New PCV Valve/Filter/Grommet
Good grounds
New negative cable
No vacuum leaks
Timing rechecked tonite - at 13-14
No codes last time I checked (2wks ago)

98% of the time it idles great. Rock steady. Love it.

Then there's that 2% where (almost ALWAYS when warm) I start it and put it in gear and the RPMs go up to about 1000 and down to about 450ish and unless I give it a touch of gas it dies. It will also occasionally die at a stoplight just like someone turned the key off. After dying it *always* cranks right back up with no problems.
Click to expand...

Have you checked the TPS and/or TFI modules? You say the idle goes to 1000 RPM then drops to 450. Mine did the same thing except it would jump to 2500 and drop slowly. It was the TPS tahe was causing it.
 

Methodical

15 Year Member
Dec 1, 2003
1,192
11
59
Clinton, MD
Jun 22, 2005
#25
  • Jun 22, 2005
  • #25
Maybe you ignition coil. If you still have your stock ignition coil put it back on and see what happens. My MSD coil has gone bad and I was having starting problems. Peace
 

Stanger007

Founding Member
Sep 26, 2001
2,015
2
46
Baton Rouge, LA
Jun 22, 2005
#26
  • Jun 22, 2005
  • #26
The new IAC didn't help at all. Car is still wanting to die upon into gear on a warm start.

Thanks for the replies - haven't checked the TPS - is there a way to check it without replacing it? Buying new parts is getting old.

I will swap on the old ignition coil tomorrow and see what happens.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jun 22, 2005
#27
  • Jun 22, 2005
  • #27
Stanger007 said:
Thanks for the replies - haven't checked the TPS - is there a way to check it without replacing it? Buying new parts is getting old.
Click to expand...
Might give this a read.
Good luck.
 

DoHcHoLlIdAy01

New Member
May 28, 2005
46
0
0
Los Angeles, CA
Jun 23, 2005
#28
  • Jun 23, 2005
  • #28
If you end up changing your TPS, there are two different part numbers available. Just keep your stock TPS handy for the part # (just in case). But I don't think that will solve your problems. 94-95 mustangs do not respond well at all to any engine mods. Just find a local programmer and ask him if there is anything he can do (to the computer) about this problem. With all the money you have spent on sensors you could have gotten a chip. Sorry don't mean to push the chip, but I went through the exact same things with mine. A big headache.
 

Stanger007

Founding Member
Sep 26, 2001
2,015
2
46
Baton Rouge, LA
Jun 23, 2005
#29
  • Jun 23, 2005
  • #29
Thanks for the help again guys - if I have time today I'll be swapping the coil, checking the TPS and running codes.

Anyone think the MLPS (senses what gear you are in) could be at fault? I bought two books on troubleshooting and tuning the Ford EEC and the description of the MLPS is that when the car is put in gear it tells the EEC to idle the car up to avoid a bog.

So dohc, do you know what the chips are changing in the EEC when they burn a chip? I ask since I will most likely get a twEECer RT instead of a chip.
 

DoHcHoLlIdAy01

New Member
May 28, 2005
46
0
0
Los Angeles, CA
Jun 23, 2005
#30
  • Jun 23, 2005
  • #30
Stanger007 said:
So dohc, do you know what the chips are changing in the EEC when they burn a chip? I ask since I will most likely get a twEECer RT instead of a chip.
Click to expand...

Your car obviously has different parameters in the CPU when running hot rather than cold. For one, you can run your fan earlier (keep cooler). I totally forgot that you can run Tweecer when the car is running. You might get the car to die at idle while tweecer is logging. That would be your best bet, if you know how to program.
 
Prev
  • 1
  • 2
First Prev 2 of 2
You must log in or register to reply here.

Similar threads

T
Help with a 95 5L crank no start
  • TheBubbaJoe
  • Nov 4, 2025
  • 1994 - 1995 Specific Tech
Replies
3
Views
446
1994 - 1995 Specific Tech Nov 5, 2025
AeroCoupe
9
Electrical F150 ECU in a Foxbody? Idle surge help
  • 93royalblue
  • Sep 10, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
416
Fox 5.0 Mustang Tech Sep 17, 2025
Mustang5L5
W
1993 LX 5.0 dies after ignition parts replacement
  • Warhorse85
  • Aug 16, 2025
  • Fox 5.0 Mustang Tech
  • 5 6 7
Replies
122
Views
3K
Fox 5.0 Mustang Tech Nov 4, 2025
General karthief
W
  • Locked
Fox Wifes 1993 LX 5.0 dies after replacing ignition parts
  • Warhorse85
  • Aug 16, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
9
Views
303
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 17, 2025
Noobz347
Engine Surging idle on start-up
  • keel
  • Aug 11, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
906
Fox 5.0 Mustang Tech Oct 31, 2025
keel
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?