Clutch Cable help..

[Ni4Ni3022]

I have an 86 2.3 stang... i put an 87 turbcoupe motor into it and the tranny with it. On th turbocoupe the bell housing on that tranny was set up for hydraulic clutch and i wanted to keep cable like i had orignally so i bought a diffrent bell housing for the T5... but the cable clutch set-up is diffrent than the typical one... it looks like the clutch cable needs to have an "L" shaped braket on the end in order to go into the lever that controlls the clutch fork... any help would be great...if you know alot aout tranny's email me and i can send u some pics of this set-up so you can help me out!!!!! thanx guys!!!

 

[rgosulliv]

i did the same thing.. if you send me pictures I may be abel to help you out. The clutch cable should only have a "ball" on the end to the tranny.

 

[Ni4Ni3022]

i did the same thing.. if you send me pictures I may be abel to help you out. The clutch cable should only have a "ball" on the end to the tranny.

what is your email adress??

 

[rgosulliv]

my email address is listed... when you click my user name "rgosulliv" you just go down to "Send Email". thats just so you know for the future.

[email protected]

Ryan

 

[kiddiccarus]

Rgosulliv Hey man I have a question that may sound stupid so regard it as such lol. I am picking up my SVO engine this weekend and wanted to go to a manual Tranny I have a 93 like yours, What Parts will I need for this job? I have an AL4D right now but am looking to get a t5 short throw in the future, so I need to ask so I get the right things from the beginning.

 

[Asha'man]

http://projecthp.ford23.com/howto.html

Ash

 

[kiddiccarus]

thanks for the link

 

[rgosulliv]

I sent you an email Ni4Ni3022. If you have any other questions just ask. I'll post the pics I sent you here too in case the email doesnt go though for some reason.

The 4 Parts your missing to connect the cable:

Part 1:

Part 2 & Part 3:

Part 4:

Diagram of where they go: (disregard the oil, had a bad leak)

Another View:

hopefully that helps you out... any other questions just ask

Ryan