considering combo change..advice??

[deepsea1969]

I'm considering changing my combo a bit. Right now I have an untuned SCT chip that was set up just to run on 30lb injectors. I'm concidering changing my setup to 24lb inj. with meter to match. Can I get some input on this?? I just don't have the time or money for the dyno right now. Thanks.

 

[fordnatic]

Unfortunately I have no input foryou, however I just built a similar combo and was curious if you have any numbers on what you have, ET or dyno results, just curious.

 

[deepsea1969]

Sorry, I don't have any numbers. If I had the time and cash to go it is tuned I would know. Right now I'm not getting what I should be getting out of the chip since it hasn't been tuned.

 

[90mustangGT]

Are you having issues with the 30's? They are a bit overkill with your combo but not by that much.

 

[deepsea1969]

I'm not really having issues, it runs great in low RPM's but on top it is flat as hell. My chip isn't tuned. It has just been set up so the 30's will run and that is it. I have a stock mass air in right now. I just don't have the cash to buy a new mass air and tune the chip. So, I'm going to put the 19's back in until I can save the cash. I even considered buying the 76 c&l kit cal'd for the 30's. But some have had trouble with C&l. Then again I had trouble with an 80 pro-m so I got rid of it. I would even consider trading someone for some 24's and a 75mm cal'd for the 24 for my SCT chip and the 30's.