crazy timing

ducatiboy06

New Member
Jun 26, 2008
5
0
0
M*******
I set the timing to 10 deg before TDC, put the plug back in, timing goes back to where it should be.. I let it run for a minute or 2, watching the mark on the crank, timing creeps back up to 10 deg or MORE ?????? Fresh built 306, mild port E7 heads, cobra intake, 70mm bbk trottle body, 160 lbs comp all cyl, new iac, tps, checked temp sensor,,,, haven't replaced O2 sensor or atmoshpheric one...... changed distrib with different used one.

I'm baffled
HELP PLEASE :shrug:
 
The plug or SPOUT enables th computer to advance the timing. When you put it back in, the computer advances the timing according to input from the active sensors. It may advance from 2-6 degrees at idle.
 
after putting in the plug, the timing goes back to about 30 deg, then as the motor runs, idle slows for some reason, and the timing mark goes back to 10-12 deg btdc ??? i thought that once the comp sets it back it should stay at that spot until the motor speed/load is increased? if i rev the motor for 30-60 seconds(2- 3k rpm, timing will return back to the 30deg

another note, timing moves a bit at idle, seems a little jumpy, what would cause it to jump a few degrees on occasion ? I just cleaned the plug spoat connections, no diff

thanks
 
Like JR said, ur computer is making adjustments to the timing based on what ur sensors are telling it. It WILL jump around at idle quite a bit. U would really freak out if u had a pms or some way to see it while driving. Mine will see 45 at some points will under light load and crusing. When ur spout is out, u take away the computers ability to do that. This is why its called "base Timing".
 
Are you running an MSD, if you are with some timing lights they can pickup the Multiple spark and it will look like the timing is jumping, the best thing to do if that is the case is just use a cheap light they usually wont pick up the multiple spark, good luck