E-Brake handle swap in 04 Cobra

It should be similar to most other SN-95 type mustangs. On my GT ragtop I removed the console to change the stock, plastic e-brake lever to a leather Cobra one. It is not difficult once you get the console off (which is the real PITA). You basically lower the brake handle and disconnect the cable (which is a lot like a bicycle brake line) from under the car. There is a small sensor on the side of the brake for the top so be careful not to damage it when you disconnect it. There is another way described in the manuals where you place a pin in an opening on the handle mechanism and somehow that allows you to remove the handle/lever. YMMV.

I didn't use the boot. You may need to unstitch it and re-stitch the boot if you are going to use it.