EGR plate

Roland69

Sergeant Tangnet
Sep 17, 2005
2,867
3
58
Port Elgin, Ontario
has anyone ever ported/honed the stock egr plate to match a bigger than stock throttle body. I just got a gt40 intake with a 70mm TB and they match perfect but now I will need a egr plate to match. anyone done this to a stock plate, is there even enough meat in one to take that much out of one. I would try to use a cyl hone and keep a close eye on the measurements as I go.
 
i havent done it to an egr, but i port matched my intake to my 70mm egr spacer. Just trace your tb onto your egr and have a look. you should be able to tell how much meat will be left if you grind it to match... what is it stock? 58mm??
 
I have read that the EGR spacer should be 2 or 3 mm bigger than the TB, if any bigger at all. Make sure the intake opening matches the 72mm egr if you go that route.

I once tried to mill the egr spacer out to 70mm on an old unit... the Ford casting has an oddly tapered bore, make sure you check both sides of the egr so once you bore the hole it still matches up with both the TB and upper intake once its all bolted on.