thanks, I would like some more info on where you mounted the coils down low if you could or if you have a picture....?? I want them unseenThat motor looks amazing Steve!
thanks, I would like some more info on where you mounted the coils down low if you could or if you have a picture....?? I want them unseenThat motor looks amazing Steve!
I dont know if I have any pics still. They were mounted on an aluminum plate with a couple of legs. The legs were clamped to the K member where the A-arms attach. Really rigged and not at all proud of what I did, haha. It was supposed to be a temp solutionthanks, I would like some more info on where you mounted the coils down low if you could or if you have a picture....?? I want them unseen
...um it is installed?
I personally don’t see the benefit to any of you guys using Coil on plug unless the coil is actually “on the plug”. the factory locates the coil as close as possible to the plug for a reason, and it’s certainly not a packaging issue.I dont know if I have any pics still. They were mounted on an aluminum plate with a couple of legs. The legs were clamped to the K member where the A-arms attach. Really rigged and not at all proud of what I did, haha. It was supposed to be a temp solution
I personally don’t see the benefit to any of you guys using Coil on plug unless the coil is actually “on the plug”. the factory locates the coil as close as possible to the plug for a reason, and it’s certainly not a packaging issue.
Why anybody would second guess the purpose of the intent, and force a 2’ or longer primary wire into the equation baffles me.
You can bet when I do the COP in the 2j those coil packs will be sitting directly over the respective plugs with as short a interconnect lead as possible.
Mike, I like the technical side of you. You are correct many use the terms loosely, but there are (2) acronyms PNP (Coil Near Plug) and COP (Coil On Plug). I do agree that its best to do COP, but they are both trying to serve the purpose of giving the spark plug the best voltage/spark possible. This is the down fall of the single coil of it charging/discharging of a 8:1 ratio over a more efficient 1:1 ratio.
I did mine strictly because I didn’t want to see any plug wiresI personally don’t see the benefit to any of you guys using Coil on plug unless the coil is actually “on the plug”. the factory locates the coil as close as possible to the plug for a reason, and it’s certainly not a packaging issue.
Why anybody would second guess the purpose of the intent, and force a 2’ or longer primary wire into the equation baffles me.
You can bet when I do the COP in the 2j those coil packs will be sitting directly over the respective plugs with as short a interconnect lead as possible.