Force Fed stang

[Blackstallion8]

Hey,
It has been a while since I last posted. I just recently purchased a used powerdyne charger and i was wondering what should i set my fuel pressure at? I have installed a Trickflow intake (street), 70mm tb, 73mm maf, 24lbs inj, and a 155lph fuel pump. I ordered a installation manual from the manufacturer but it doen't state this info. Also where would my boost line go so i can install a gauge? and do i need to by some kind of solenoid to relieve the built boost upon letting off the throttle? Will i need a 6al box or some knid of similar ignition module for the timing and rev limiter or will i be fine? :SNSign:

Sorry, so many questions so little time.

 

[Marlboro_Man]

The hose for the boost gauge can go to the vacuum tree on the firewall.

A tune would be best , an msd 6al or digital6 would also be nice to have but not a neccesity.

And yes you need some type of relief valve to let out the pressure when you let off the gas.

 

[Blackstallion8]

WEll on that tree there are four ports right? and one is not being used thats where the charger will hook up to so would i install a tee in that line? That controller you are selling would that work good with my setup?

 

[Marlboro_Man]

I don't quite understand what you mean by "thats where the charger will hook up to".

If you wanna install a boost gauge thats where you wanna hook it up, or you can hook it up to any other unused port on the upper intake manifold.