Fox Ball Joints

hemi_fan

Active Member
Apr 8, 2004
279
3
28
Ontario, Canada
My ball-joint just split in half yesterday, and now I am in need of replacements. I checked my Haynes manual and it says that the ball-joints are not replacable and that the entire A arm must come off and be replaced. Is this true, or can I get the ball-joints out somehow? Because I have seen individual ball-joints for sale for fox cars which makes me confused.
 
Ball Joints repalced

I just pressed the lower ball joints out of my 91 Stang on both sides with no problem. NAPA sells replacement ball joints. Of course they would rather sell you the whole lower control arm!! If the arms are in good shape along with the bushings, just change the ball joints.I just replaced the steering rack, outer tie-rod ends, and lower ball joints. Car had 130,000 on original front end parts. Made a big difference in the ride. You just need to get a press to press them out and press them in. AutoZone may have one you can rent. I borrowed one from a friend and changed them right in my driveway.. Not a bad job, took about 1 hour to change the ball joints out!!

P.S YOU WILL NEED A WIDE BALL JOINT FORK ALSO, TO RELEASE THE BALL JOINT FROM THE SPINDLE. THE AUTO PARTS STORE WILL KNOW WHAT YOU'RE TALKING ABOUT
Good Luck,

BLK3dgt
 
donsbad68 said:
You split your ball joint? How painful was that? J/k. You can replace them. Its not hard.

lol, I got lucky... The steering started to feel really funky, and then i started to get a wierd vibration/wobble and i thought I had a flat tire. I pulled over to see if I had a flat, and did a quick visual inspection but everything looked fine. Went to pull away, and the front left tire just dropped. Luckily I was only going about 5km/h when it happened and I was already off the road... Scary though, the ball came right out of its socket... dry as bone, no grease left at all. Thanks guys, I'll be borrowing a fork and puller!
 
hemi_fan said:
l Thanks guys, I'll be borrowing a fork and puller!
Dont forget the press. It looks like a Big C-clamp with some adapters.

Make sure your control arm bosses arent out-of-round or hogged out too bad (most aftermarket BJ's are a hair larger than OEM to maintain the press fit).

If you have the cash, it's hard to go wrong with the new loaded arms from Ford. Especially if you find that you need bushings..............

Good luck.
 
well mine snapped last week, i bought the new A-arms from jegs with the 96-04 upgraded balljoints. these things ROCK!! corner and handling is 100x better, road feel...and for 200 to your door it was great. took me about 4 hours to replace both sides not really rushing in my garage.
 
89white50 said:
well mine snapped last week, i bought the new A-arms from jegs with the 96-04 upgraded balljoints. these things ROCK!! corner and handling is 100x better, road feel...and for 200 to your door it was great. took me about 4 hours to replace both sides not really rushing in my garage.


X2 for the Ford Racing A Arms!