Goal 210 RWHP

Riggs · Apr 9, 2007

Would the mods - tune, intake, muffler, pulley, and a driveshaft be enough for my V6 stang to achieve 210 HP at the wheels?

hutcccch · Apr 9, 2007

Headers would help but theres really no way to tell you, until you actually do it an dyno the car, ever car is different.

Riggs · Apr 10, 2007

I thought headers and even a new throttle body are things on the new mustang that really don't gain much power.

glewis29 · Apr 10, 2007

According to PHP, JBA headers and an axle-back muffler gave them 17 RWHP. Adding a retune, and air intake raised it up to 20 RWHP gain. Their V6 started at 170 RWHP and went up to 190.

http://www.jbaheaders.com/articles/50Mustang_306.pdf

Add a pulley and a higher octane tune and you'll be getting close

scrming · Apr 10, 2007

Riggs said:
Would the mods - tune, intake, muffler, pulley, and a driveshaft be enough for my V6 stang to achieve 210 HP at the wheels?

Automatic or manual? 210RWHP for a automatic is going to be pretty tough with just bolt-ons...

and you are correct.... TB's have show Zero gains... Headers will get you some HP... but not a whole lot considering the cost and labor of doing headers... Most of the 17RWHP the PHP seen doing the JBA exhaust is most like from getting rid of the stock muffler.. a GT take-off muffler has shown to be could for 10RWHP itself... LOL

glewis29 · Apr 10, 2007

Well, I have just the JBA muffler on atm, so I could go get it dyno'd... how much should I pay for just a dyno test?

FBullitt · Apr 10, 2007

scrming said:
Automatic or manual? 210RWHP for a automatic is going to be pretty tough with just bolt-ons...

and you are correct.... TB's have show Zero gains... Headers will get you some HP... but not a whole lot considering the cost and labor of doing headers... Most of the 17RWHP the PHP seen doing the JBA exhaust is most like from getting rid of the stock muffler.. a GT take-off muffler has shown to be could for 10RWHP itself... LOL

How does the gains of the GT take-off compare with the magnaflow single, the Flowmaster AT single and the Ford Racing mufflers ?

I am down to these three and am leaning toward the Magnaflow since it seems to not be quite as loud as the rest.

bigcat · Apr 11, 2007

glewis29 said:
Well, I have just the JBA muffler on atm, so I could go get it dyno'd... how much should I pay for just a dyno test?

in my area a baseline pull is about $90. that gives you one hour dyno time, and as many runs as you can get in.

Riggs · Apr 11, 2007

I have a manual Trans and i would like to do a lot of performance mods in the weak areas like first off the Ford T-lok, then an intake and a tune(which tune yet I don't know, whomever is the best for a manual), then probably a muffler (Flowmaster), driveshaft, then a pulley, and probably eventually LCA's. Another question - should upper arms be done with lower arms or are LCA's good enough?

rmays06 · Apr 11, 2007

I'd say go for the Flowmaster. 210 sorta hard but doable. I'd settle for 14.5 track times over 210RWHP...JMO

sleeperstang06 · Apr 15, 2007

Riggs said:
Would the mods - tune, intake, muffler, pulley, and a driveshaft be enough for my V6 stang to achieve 210 HP at the wheels?

whats up everyone i'm new to this part of stangnet, but i have an 06 manual with pony package. I put on the GT flowmasters with 2.5in H pipe and got my car dyno'd. it ran 203rwhp with 20 inch rimes. i'm going to be re tuning it and getting an intake in the next month and eventally a supercharger or maybe turbo. hope i could help.

rmays06 · Apr 15, 2007

sleeperstang06 said:
whats up everyone i'm new to this part of stangnet, but i have an 06 manual with pony package. I put on the GT flowmasters with 2.5in H pipe and got my car dyno'd. it ran 203rwhp with 20 inch rimes. i'm going to be re tuning it and getting an intake in the next month and eventally a supercharger or maybe turbo. hope i could help.

Like was stated earlier every car is different you have a nice engine there 203with those mods. Great numers...

Goal 210 RWHP

Riggs

Member

hutcccch

New Member

Riggs

Member

glewis29

New Member

scrming

New Member

glewis29

New Member

FBullitt

New Member

bigcat

start with the upper hole, and if more traction is

Riggs

Member

rmays06

New Member

sleeperstang06

New Member

rmays06

New Member

Similar threads

Goal 210 RWHP

Member

New Member

Member

New Member

New Member

New Member

New Member

start with the upper hole, and if more traction is

Member

New Member

New Member

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency